Search results
-
Battery terminal is toasted
Try checking the water level in the battery. If it is low refill with distilled water.- jeepkj02
- Post #9
- Forum: KJ General Discussion
-
stupid part time sensor
I would just ignore it. Do what others do, put some electric tape over the signal and forget about it.- jeepkj02
- Post #2
- Forum: KJ General Discussion
-
Battery terminal is toasted
Did the terminal actually crack?? If it did, then you will have to cut it off and crimp in a new one. I had to do that to my negative terminal. To keep the corrosion away, I use dielectric grease, or petroleum jelly to keep it from corroding again. Check it periodically.- jeepkj02
- Post #7
- Forum: KJ General Discussion
-
Out of These Three Cragars . . . .
Even though I somehow ended up with the D-windows I like the Soft 8's better.- jeepkj02
- Post #13
- Forum: Tires / Wheels
-
Shes getting old...
I only got 80K on my '02. Yours is still getting broken in. :)- jeepkj02
- Post #16
- Forum: Post Your Liberty Pictures
-
Which ARB Air Compressor?
Don't buy anything from Rocky Road, they are know for their horrible customer service!!- jeepkj02
- Post #2
- Forum: KJ General Discussion
-
Clevis lift help
So I don't have a clevis lift?? Hmmmm......that does explain why the bottom end of my shock sits flush with the clevis. I always wondered that.- jeepkj02
- Post #14
- Forum: Lift Kit Discussion
-
Winter Switch
You sure love black cars!! Nice Crossfire!!- jeepkj02
- Post #2
- Forum: Post Your Liberty Pictures
-
What does everybody pay for their fuel
2.22 for regular 87, 2.32 for midgrade 89. Decided to run a tank of 89 octane- jeepkj02
- Post #284
- Forum: KJ General Discussion
-
HELP! I cannot get the old spark plug out!!!
warm up the engine a bit, not at fully operating temperature but for few minutes (3-4 minutes) and got at it again. The cylinder heads are aluminum and the treads on the plug are steel, so careful not to cross thread it.- jeepkj02
- Post #3
- Forum: KJ General Discussion
-
Rear Interior Rack
Here is how I mounted the backside of the rack. What do you recommend wrapping the shelf in. I was thinking either carpet or maybe vinyl??- jeepkj02
- Post #6
- Forum: KJ General Discussion
-
New and in need of help.......PLEASE
I heard of the window regulators failing on the newer model KJ (usually 06-07), but never on 02s. As for the front driveshaft, you cant replace only one CV, the whole shaft has to be replaced. I know someone has replaced it with a regular U-joint shaft, but it will be $$$!!! I guess it is just...- jeepkj02
- Post #3
- Forum: KJ General Discussion
-
Leveling Suggestions???
Nope, it is just the original upper isolator. Basically stacking an additional one on top of the factory one to give you 1/2" lift. The CJ/YJ came with leafs springs all around.- jeepkj02
- Post #14
- Forum: Lift Kit Discussion
-
Leveling Suggestions???
Uppers.....just get them from your local friendly stealership. You may find them cheaper on the internet for a couple bucks less, but after you factor in shipping its about the same.- jeepkj02
- Post #13
- Forum: Lift Kit Discussion
-
4x2 vs 4x4. Need Help
"KJ" doesnt stand for anything, it is just a designation that Jeep gave each model. http://www.jeepkj.com/forum/showthread.php?t=27272- jeepkj02
- Post #4
- Forum: KJ General Discussion
-
HOW TO: Change Transfer Case Fluid
I use a bottle pump, no spills to worry about!! I got one for gear oil and one for ATF. -
Rusty's 2.5" Strut Spacer Lift Kit Tire Clearance?
Stay FAR, FAR, FAR, FAR, FAR away from that lift!! It will blow your struts and basically destroy your front suspension and ball joints. Just get some OME HD springs and Rancho shocks and struts. For bumpstops, I used 2 hockey pucks in the rear, drilled a hole in the spring perch used a bolt and...- jeepkj02
- Post #2
- Forum: Lift Kit Discussion
-
Rear Interior Rack
Thanks for the link BluPhant. Have an idea I'll see if it works tomorrow. I'll post more pics tomorrow if it works. After that I cover it with some carpet. Socks, thanks for the inspiration!! :)- jeepkj02
- Post #4
- Forum: KJ General Discussion
-
Rear Interior Rack
Got the dimensions (48x16.5) off of LOST, got the front mount taken care of but not sure how to mount the rear part of the shelf? Took some pictures, thinking I could use the seat latch somehow?? Ideas??? idea.gif- jeepkj02
- Thread
- Replies: 9
- Forum: KJ General Discussion
-
a newish guy
I wish every KJ came like that from the factory!!!! :rolleyes: I looks like a d-ring turned on its side.- jeepkj02
- Post #3
- Forum: Introductions
