Search results

  1. R

    What did you do to your jeep today?

    Today I found a pine needle stuck in my idle air control motor causing high idle.
  2. R

    What did you do to your jeep today?

    I bought a 2004 liberty with what I thought was a blown head gasket for $300, and when I tore the head off it looks like the piston was partially melted along with the head on both sides cylinder 1 and cylinder 2.
  3. R

    The good news is that both headlights still work! (Thank you forum!)

    I would buy it back for sure. It doesn't look like you have any major damage at all. In fact your damage looks like mostly plastic damage and that stuff is cheap. The main core support looks fine.
  4. R

    Right Rear Door Glass Regulator Broken and door wont open.

    I would pull on the cup holder that built into the panel.
  5. R

    Greetings of humble Wisdom

    As for lockers I would using a limited slip in the rear and a selectable locker in the front.
  6. R

    What did you do to your jeep today?

    I would swap the manifolds for a set of headers and then you can say bye bye to the cast manifolds.
  7. R

    242J (Selec-Trac) swap for 6spd

    I swapped the 231 for the 242 and I love having the option of full time 4 wheel drive.
  8. R

    Anyone have to cut control arms out

    I had to cut my lower control arms out and man what a fun job that was. It took forever!
  9. R

    Removing Fan Clutch from Water Pump

    First off you have the incorrect clutch fan. The stock clutch fan is 11 blade white plastic. Secondly I would just buy a new fan clutch off of rockauto.
  10. R

    Alternator Conversion help

    The blue sense wire is not needed just put a wire nut with some electrical tape on the end of the wire.
  11. R

    White smoke in 4WD?

    Have you checked the oil level in the transfer case?
  12. R

    DIY Engine mods for a jeep liberty?

    I would bore out the throttle body, don't touch the throttle plate and it will improve throttle response. I would also insulate the intake this includes the intake box as well. It lowers intake temperature and it also looks cool. Also running more engine grounds helps to make sure the jeep has a...
  13. R

    2003 Jeep Liberty 3.7 4wd

    Welcome! Most likely the noise is either the axle bearings or the pinion bearing. I would replace the axle bearings and see how it goes from there.
  14. R

    What did you do to your jeep today?

    I bought a truck to use in the winter, the jeep is the fun vehicle and also my first vehicle.
  15. R

    What did you do to your jeep today?

    I am clearing my driveway for the jeep to sit in winter storage. I plan on taking the wheels off and also putting the jeep on jack stands to take all the weight off the suspension and then covering the jeep up with several tarps. I am also going to take the plates off as well to save money on...
  16. R

    New here

    Welcome!
  17. R

    $50.00 Ebay Radiators

    What ever you do don't buy a napa radiator they are junk. The junky napa radiators almost cost my family 2 engines, that would be the one in my jeep and one in my brothers Mitsubishi.
  18. R

    TPMS issues

    Sounds like a bad sensor, I have had a few bad sensors before rite out of the box.
  19. R

    New to this site.

    Welcome!
  20. R

    newest new guy!

    Welcome!

Random media

ford_killer
165553094
cupholderradiomount1
Water level at front door
20131007 164548
0116141230
150220111361
20131109 130656
4844.jpg

Latest posts

Members online

Total: 447 (members: 6, guests: 441)
Top