Search results
-
Does my parts list look ok? Suggestions?
No.. two hockey pucks on each side for the rear (total of 4, installed on the lower spring perch) then get the teraflex bump stops for the front (replaces the factory stops)- Snail Farmer
- Post #10
- Forum: Lift Kit Discussion
-
rear spring swap
Should have two hockey pucks on each side- Snail Farmer
- Post #8
- Forum: Lift Kit Discussion
-
Monroe Load Adjusting Shocks - Installed
Hmm I like the price tag too. I'll probably replace my blown Ironman shocks with these.- Snail Farmer
- Post #8
- Forum: Lift Kit Discussion
-
235/75/16s?
Yes they are quite possibly the worst tire ever made lol.- Snail Farmer
- Post #9
- Forum: Tires / Wheels
-
AC issue
Coolant from the radiator or refrigerant from the condenser?- Snail Farmer
- Post #30
- Forum: KJ General Discussion
-
AC issue
When you turn the temp knob between cold and hot there is a door that moves to route the air. I'm not sure how to get to it or the easiest way to check it on the liberty. I've never had to mess with mine before. Hopefully someone who has can give you more info.- Snail Farmer
- Post #10
- Forum: KJ General Discussion
-
-
My jeep was stolen this morning!!!
^ This is what I was thinking exactly- Snail Farmer
- Post #37
- Forum: KJ General Discussion
-
Lift help asap. Shipped wrong rear shocks maybe
Thanks for pitching in Luke I was outside replacing an alternator for my neighbor.- Snail Farmer
- Post #9
- Forum: Lift Kit Discussion
-
Lift help asap. Shipped wrong rear shocks maybe
When trying to align the clevis (strut fork) with the LCA I used ratchet straps. I hooked one end to the LCA and the other end I just hooked in the holes of the skid plate so it pulled the LCA down enough to push the clevis in. If you don't have skid plates maybe someone else can chime in how...- Snail Farmer
- Post #4
- Forum: Lift Kit Discussion
-
-
Stripping O2 Sensor
I would recommend heating it with a torch- Snail Farmer
- Post #2
- Forum: KJ General Discussion
-
Creaking noise?
Mine used the same joint for both ends but mine is a manual. Not sure if that makes a difference- Snail Farmer
- Post #11
- Forum: KJ General Discussion
-
Creaking noise?
X2.. only one of mine was bad but I replaced both while I had it off.- Snail Farmer
- Post #8
- Forum: KJ General Discussion
-
How-To for changing rear U-joint?
Disconnect the diff end first (4 bolts), you might need a hammer to knock it loose once the bolts are out, then slide the driveshaft straight rearward. The output shaft coming out of the t case is splined and the driveshaft just slides off. There is a clamp on the boot at the t case end you'll...- Snail Farmer
- Post #12
- Forum: KJ General Discussion
-
O2 sensor and P0133 code
On my 04 IIRC the plugs are the same for up/down stream.- Snail Farmer
- Post #8
- Forum: KJ General Discussion
-
My jeep was stolen this morning!!!
Oh man that sucks. Hopefully they find it soon and it hasn't been damaged.- Snail Farmer
- Post #3
- Forum: KJ General Discussion
-
rear cargo shelf
Yeah we have to 5S at work.. good in principle but sucks sometimes- Snail Farmer
- Post #101
- Forum: Fabrication
-
New kj rear bumper in the works
I'm not a huge fan of the holes on the face but then again it would make a good spot for more back up lights.- Snail Farmer
- Post #33
- Forum: KJ General Discussion
-
Rust Repair
I take mine through the full service wash.. only $11 and I sit on my ass while they wash it for me. They spend a good 15 minutes on just the under carriage, then hand wash it, then send it through an auto wash, and then hand dry it. I wish I still lived in NC though. The Ford dealership there...- Snail Farmer
- Post #28
- Forum: Detailing / Cleaning
