u2slow's latest activity
-
u2slow replied to the thread Rear sway bar.I kept it. Felt the rear was pretty soft overall after lifting. Then I added load-assist shocks. -
u2slow replied to the thread Heavy duty rear coils.I put in the load-assist (coilover) style rear shocks to firm things up. Believe they were Durango application.
-
u2slow replied to the thread Will KK front end struts and spring work on a KJ?.I run the KK clevis for a bit of lift. The top part of the KK strut is the wrong angle - it's likely just the plate. Also running...
-
u2slow replied to the thread ABS/Traction Control disables on low traction surfaces.I think you're putting too much reliance on a finicky system. Our '05 has no ABS or traction control (factory) and it's been an...
-
u2slow replied to the thread Can I Fit ANY 4.10 Gears by Just Adding ANY Steel Dana 30 Carrier into the Dana 30a “Super”?.I have to admit, I'm over the steel diff idea. I ran a locker for while and didn't break anything. 311,000km now with half that on 3"...
-
u2slow replied to the thread Head interchange.The combustion chamber and cam profile change from 04 to 05. https://www.motorreviewer.com/engine.php?engine_id=180 I have mismatched...
-
u2slow replied to the thread lower ball joints.I still have the stock ones at 310,000km. They have endured a 3" lift for half of that. With jobber parts, i have best luck with...
-
u2slow replied to the thread 2002 liberty difficulty getting into and out of 4 wheel drive ?.Maybe the shift cable is seizing up? Check the bushing/grommet on the end of the cable? Shift fork pads (nylon) inside the tcase can...
-
u2slow replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.I confirmed the crush sleeve interchange is with the JK. This should be it https://www.randysworldwide.com/shop/sk-csjk-f
-
u2slow replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.I don't have the answer, but I got crush-sleeve eliminators instead. I don't have the experience or confidence to get this stuff right...
-
u2slow replied to the thread Replacing Head Gaskets.Push it back with a prybar from above. Bend wire into a long L shape and force it into the little hole to pin it.
-
u2slow replied to the thread Replacing Head Gaskets.I studied this video to see how the tensioners worked and how to pin it. Fishing line is small enough to pull the chain taught and...
-
u2slow replied to the thread Liberty 3 hole rear brake backing plate/ dust cover..Afaik, same axle, but with some revisions for 06-07 for the traction control's wheel speed sensors.
-
u2slow replied to the thread Replacing Head Gaskets.The FSM wants you to tear it all down so you can access the chain and tensioners - preferably renew them also. And gain access to pin...
