tyates007's latest activity
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Thank you. That was my thought as well. I know on when I was looking at specs on my wrangler Dana 30 the preload for new bearings was...
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Reassembled tonight and crush sleeve although tough was not 500 ft/lbs tough as mentioned. It took a lot of force to start the crush and...
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Thank you. I plan to do the same. Seemed pretty high to me as well.
-
Ttyates007 reacted to JeepJeepster's post in the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? with
Like.
That cannot be correct. I installed 4.10's in my front diff and did not get anywhere near that. Pretty sure I recall torqueing to 160... -
Ttyates007 replied to the thread ASFIR 4x4 skid plates.I will definitely report back. Will be a couple of weeks. They arrived last week. Looking at them I do not see any concerns with the gas...
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Thank you!
-
Ttyates007 reacted to u2slow's post in the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? with Like.
I confirmed the crush sleeve interchange is with the JK. This should be it https://www.randysworldwide.com/shop/sk-csjk-f
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Sorry, did not mean it felt weak. Just meant it did not look like it would take double the torque to crush as the one in the rear 8.25...
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Thank you. I planned to do just as you shared. My manual is a 2003 and there is a lot of discrepancies in it for torque on a lot of...
-
Ttyates007 replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Thank you. Looking forward to your reply
-
Ttyates007 posted the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? in KJ General Discussion.Getting ready to do final assembly on the front differential with 4.10s and DTT. When I look at the manual it states to torque pinion...
-
-
Ttyates007 replied to the thread ASFIR 4x4 skid plates.Will report back once I get them installed or not. In the process of regearing the front right now
-
TI have these on my 06 crd. They fit fine. I don't exactly remember, but I might have had to elongate a hole or two with a file or burr...
-
Ttyates007 replied to the thread ASFIR 4x4 skid plates.Thank you. I contacted them and they said they were unable to confirm due to only testing on CRD. I know on the gas KJ the transmission...
-
TI was looking at these ASFIR skid plates. They look pretty nice. https://www.asfir.com/underbody-protection-kit-541055b.html They show...
