Recent content by scomagg

Finished lift that started last fall Finally got around to finishing the lift- 2007 KJ Limited OME HD springs F/R Bilstein Frnt shock BDS rear shock 2 extra ISO's rear 2 - conduit nut clevis front Hanger angle brake line relocation mod 15x7 Cragar D Windows 31x10.5r15 General Grabber AT's...

I've searched the forum extensively but not yet found anyone who has definitely mounted the TPMS on cragar Soft 8's. I want to put the 15x7 soft 8 on my 07 limited with the TPMS. The wife will never allow any beeping/lights/warning chimes at startup so I MUST have the TPMS functional. Some...

Yup - I thought so also. But, I haven't seen many '07 on the site, and I have yet to find an 07 that someone measured the stock heights at this mileage. Have you seen any one else's measurements? Is it possible the limited's have a different fender flare profile?

2007 Limited 70k miles on stock suspension, ~20 miles on lift OME HD all around Bilstein BE5D916H0 front BDS 55968 rear pre-lift - 19.5" all around post lift - 22" all around no clevis

Thanks

I ordered two from the dealer. $3.40 each. This is what everything was tightened to: Front Ball Joint Nut (Upper) 21mm 60 lbs-ft Front Clevis Bolt (Upper) 21mm 100 lbs-ft (WRONG) Front Shock/Strut Mounting Nuts 18mm 80 lbs-ft Front Sway Bar End Link (Lower) 18mm 85 lbs-ft That's all...

Appreciate all the replies. If you were asking me, I was going to tighten to 100ft-lb per the torque specs on the Wiki. I can see now that is way wrong. It's an '07 Limited, manufacture date on the door is Dec '06. The broken bolt was labeled "10.9" I've included pics. I got a new...

Completing the install of OME lift, using torque wrench to tighten clevis bolt, snapped the bolt at under 100ft lbs ... Any one else had this experience? or is my torque wrench off? Thanks

Tommudd - thanks for taking a look. I'll probably re-use the stock ISO's unless they are toast.

Thanks for the reply - Pic uploaded.

RE: Awesome, thanks for the input. I really didn't want to have to ship these back.

I've been reading around quiet a bit on the site, and I bought a OME 2927/Bilstein setup for the 07 KJ LTD. I had a question regarding the front coils - the 2927's do not sit flush on the spring seat - the very end of the coil touches but the rest of the first coil does not. My concern is that...