-
-
January -
Rene_05 replied to the thread 4.10 Re-gearing - 2025.https://www.uspowertrain.com/product/new-2002-2007-jeep-liberty-dana-30-ring-and-pinion-410-ratio This is where I got mine. Not...
-
Took the jeep on a road trip to Moab again. We did more hiking than wheelin' this trip, but I did manage to hit the driveshaft on a...
-
I'm using usa standard gears in the rear, which are said to be a lower tier than Yukon. They are fine. Noise isn't bad, honestly pretty...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.I wasn’t able to find a shop to install before being out of state, so can’t comment yet. Has anyone else used Yukon rear gears or have a...
-
Wifey had major surgey and is recovering well, so finally had some time to work on Bert in between wound care and drain purges (gross...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.Thanks, great explanation! After I posted I thought wait a minute, transfer case wouldn’t allow the front and back to ‘connect’ in 2wd.
-
Yes the gears are turning, but they are open diff and more importantly are disconnected from the transfer case. By leaving the t-case in...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.I might be thinking too hard about this, but just want to make sure I do it right. The gears in the front should be turning even if not...
-
Omg yes I followed your winter gear swap. That had to have been brutal. Maybe in my younger years…lol By the way Rene_05 that is a darn...
-
When I did my calling around every place I spoke with wanted the rear axle to remain in the Jeep during rebuild. And that is how I did...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.A little perspective definitely helps with all this.
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.I think we might already be there. Probably not enough demand to keep making them.
-
IFS diffs vary quite a bit in their construction. Some can be very finicky to setup right, so shops either shoot high, or try to not...
-
-
Loading…
-
Loading…
