Recent content by NMKJ

I am considering a slight lift, so that is good advice, I appreciate it.

So I went out and check tonight The CV axles have both been replaced semi recently. They both have good boots on them, but the passenger side is what I feel is making the noise. I also grabbed the the CV axle where it meets the inner shaft pictured above and there was no noticeable play in it...

Gotcha. That explains it. Without getting it onto the hoist I really dont have an idea right now. Hopefully I can get it up on a hoist this weekend and start tearing into it and figure it out. Perhaps the CV axle is just fine, and all I will need is that axle bearing listed in the part blow up...

I found this video on youtube and it sounds identical to this. One of the comments suggests its the axle bearing. Number 22 in the Dana 30 link below? https://www.youtube.com/watch?v=v-cXGo77PiE Dana Model 30 Front Axle for 2002-2007 Jeep Liberty KJ at Morris 4x4 Center Ill take a look at...

If I buy that whole assembly is that all I will need to fix the issue? Besides of course replacing the ball joints while I am there (I dont feel like taking the knuckle off again in 10,000 miles to replace the ball joints lol)...

Thanks for the fast response guys. The ball joints are original, so while I have the knuckle off to replace that I probably will just throw in new ball joints with it. Is this the part I'm looking for? Just the whole assembly, or are there other bearings I'm going to need as well? --->NAPA...

Hello, I am new here, and I just bought a KJ. I have owned a TJ before but this is my first KJ. The problem I am having is a decently loud humming from the front passenger side. It does not change when you apply throttle except for getting faster as the vehicle speeds up. It sounds like a loud...