Idk if the center shaft was flush with the crank pulley but close. I just screwed the but back on and it looks like its close to where it was, it being the center shaft the pulley is on. Should I just crank down harder on the pulley puller? It got very hard to turn that's when i stoped and made...
Well the center hole of the pulley was flush with the crank after turning the puler it has moved probably 1/4" to 1/2" back. I have pics just dont know how to post them. I tried kroil and some heat. Nothing. There isn't any more bolts besides the center bolt?
So I'm trying to do a head gasket Nov on my 02 Libby 3.7. I'm down to removing the crank pulley and I'm stuck. I have a 3 has puller in it at the tabs. Made sure everything was straight. The problem is as im cranking down on the wrench, the pulley won't move but the crank(?) or whatever the...
So I just stuck my finger in the rear diff hole. Got dark gray gunk on my finger but didn't touch any fluid. My finger went about 1.5" in the hole. I have gear oil at the house. Will add some when i get home.
So I've put about 400 miles on it. No smoke. Did get a p0304 so I removed that plug and saw some oil coating the plug. Cleaned it off and all back to normal. So I'm just not rly going to worry bout it. As long as it's running fine. Just trying to figure out the whine while driving now.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.