Recent content by Milkman00
-
M
AC question with gauges
I had the system evacuated by a shop the first time, but I don't know how much oil was pulled. Is it fair to say that if I have it evacuated and flushed this time, there would be 0 oil in the system? I will do that this time if I need to. As far as the scale goes, I just want to make sure...- Milkman00
- Post #9
- Forum: KJ General Discussion
-
M
AC question with gauges
Previously I guesstimated the correct amount of remaining can (26oz total system capacity, so 2 cans plus "a little bit". Ok let's start again. I am going to have the system evacuated again. Also I went and purchased a digital scale today. Two questions If I zero out the scale with...- Milkman00
- Post #7
- Forum: KJ General Discussion
-
M
AC question with gauges
The old AC bearings were going bad in the compressor, so nothing bad should be in the lines/condenser/evaporator. I used the plain old 134a cans that don't contain the extra junk you are referring to. How can I tell by what the gauges are doing if it is over charged or under charged? I...- Milkman00
- Post #3
- Forum: KJ General Discussion
-
M
AC question with gauges
Hi all, 04 Liberty 6cyl. I did my first AC job ever. I have avoided AC for a very long time, mainly because I didn't know much about it. I wasn't going to pay a ton of money to fix my broken compressor, so I thought this would be a good time to learn. Got a new compressor, dryer, and...- Milkman00
- Thread
- Replies: 9
- Forum: KJ General Discussion
-
M
AC recirculate setting issue- Not blowing hard
I am sorry to bump this old thread, but I was having the same exact problem with my 2004 Liberty. I took the glove compartment down and my screen looked almost identical. I vacuumed it out, brushed it off, and it blows WAY harder now. Not quite as cold as I would like it, but definitely...- Milkman00
- Post #29
- Forum: KJ General Discussion
![IMG 3818[1]](/data/xfmg/thumbnail/3/3266-7aa03c0c22806db22666727a80262a92.jpg?1623784620)
