Recent content by Gwraalstad

I have two BCM's with the same part # but different Serial #'s as the one in my 2003 Jeep Liberty. I going to presume that the ser# identifies with a specific VIN when it is programed. Can they be reprogramed to work in my vehicle? I tried to just swap them out to see if they work but to no...

Called Car Computer Exchange. They don't repair Jeep BCM's just PCM's. I know it is the BCM because I swapped out a 2004 BCM and finally got low beams but when I went to test the high beams, I got a lot of flashing lights on my instrument panel and no high beams. Maybe I just need that one...

TX very much.

I have a 2003 liberty 3.7 with a BCM # 05093038AA. I went to a U-pull-it scrap yard and found a 2002 and a 2004 BCM # 56010420AH. Paid $20 each. Great Condition. Is this number interchangeable with my 2003? They are a year before and after. Is there something about a 2003 that they have a...

Update on the, NO LOW BEAM ISSUE. I finally found the problem but need suggestions on how to fix it. I pulled the Low beam relay and tested it. It was ok so I checked to see if there was power to the relay. Removed the relay and connected a spaded wire to # 1 terminal, no luck. Then did the same...

Update on the, NO LOW BEAM ISSUE. I finally found the problem but need suggestions on how to fix it. I pulled the Low beam relay and tested it. It was ok so I checked to see if there was power to the relay. Removed the relay and connected a spaded wire to # 1 terminal, no luck. Then did the same...

Update on the, NO LOW BEAM ISSUE. I finally found the problem but need suggestions on how to fix it. I pulled the Low beam relay and tested it. It was ok so I checked to see if there was power to the relay. Removed the relay and connected a spaded wire to # 1 terminal, no luck. Then did the...

OK Guys/Gals. I have read all the threads on how to fix this problem but to no avail. I've tested all the relays and they all work. I have power through the fuses for the high beams but no power through the fuses for the low beams. Attached is a pic of the back side of the Junction Box. Had...