Latest activity
-
SGood luck. Looking forward to hearing how it goes.
-
JeepinSteve replied to the thread Deeke's upper control arms?.Good luck. Looking forward to hearing how it goes. -
Sseafish replied to the thread Rear upper control arm wont go in all the way.I did the same, a jack under the rear end and a slight rotation and it slipped right in. Kind of just like … oops wife just walked in ;)
-
Sseafish replied to the thread Deeke's upper control arms?.+ = thumbs up @duderz7 You know you're on a really good forum when the second post in a thread nails it. ;)
-
Couldn't find an original clutch out of the 5 Liberty's I saw, so I grabbed this UAC Korea compressor that looks to have been installed... -
lfhoward reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with
Haha.
It can’t be tight if it’s liquid… -
SStueyD replied to the thread Deeke's upper control arms?.I'm going to try and fit one of the arms tomorrow,. I'm partly thinking, that even without the washers I'm going to have to trim these...
-
JeepinSteve replied to the thread Deeke's upper control arms?.Just from your experience installing these control arms, do you think it would help to get bushings with a thicker outer lip so you...
-
blackhawk replied to the thread P0765 Shift Solenoid "B"question..Btw, if you have the diagram, you can check if UD solenoid is in good condition with a multimeter in ohm. It must be between 1.6 to 2.3... -
SStueyD replied to the thread Deeke's upper control arms?.It's exactly that, the nipple's get in the way i.e. can't get it high enough and wouldn't trust it if they were on there, as in it looks...
-
blackhawk replied to the thread P0765 Shift Solenoid "B"question..P0765 UD solenoid circuit Possible causes: Transmission control relay output circuit open Ud solenoid control circuit open, short to...
-
JeepinSteve replied to the thread Deeke's upper control arms?.Hello Stu. I have not had an opportunity to install them yet. What is the problem you are having installing them? Does the inner...
-
224turbo replied to the thread P0765 Shift Solenoid "B"question..The relearn should be done by the shop doing the work (with a scanner). I mentioned it just for your awareness. The procedure you...
-
SStrizay replied to the thread P0765 Shift Solenoid "B"question..I ran the VIN and it has 3.7L ENG (EKG)/4SPD A/T 42RLE (DG6). I have faith in the guy installing it, I've been going to him on and off...
-
SIf you have a 42RLE that is the correct solenoid pack. Just double check you dont have a 45RFE as I believe some early 03s came with...
