Grease fittings on sway bar bushings?

[andersonbc]

You must be registered for see images

Anyone done this yet? I bought some grease fittings today and I plan on doing this tommorrow. I was wondering if anyone might have some tips before I get started?

 

[valvestem]

Are you using the stock bushings and brackets? Those red ones may have a molded in groove in the surface to allow the grease to travel from under the fitting. I don't know how you'd put a groove in the stock rubber ones.

You must be registered for see images

Anyone done this yet? I bought some grease fittings today and I plan on doing this tommorrow. I was wondering if anyone might have some tips before I get started?

 

[andersonbc]

Good point, I'll decide what to do once I remove the sway bar.

 

[Bennett]

Let us know how it goes. My sway bar is starting to squeak so I am going to have to do something soon.

Bennett

 

[andersonbc]

Unfortunately, none of the local hardware stores had a tap for a 1/4 x 28 thread (the same as the grease fittings). I still plan on doing this sometime after I find the right part