GeekFisher '03 Liberty Sport 3.7 4x4

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

GeekFisher

Full Access Member
Joined
Jan 21, 2016
Messages
113
Reaction score
1
Location
Quebec
OK, did great work during the week-end and I'm almost "finished" with the project...

So I know pictures are appreciated so I took a few:

LED reverse backup light:
You must be registered for see images attach

Phillips LED brakes and LED third brake light:
You must be registered for see images attach

Sylvania Silverstar High beams:
You must be registered for see images attach

Silvania Silverstar Low w/ Fogs on
You must be registered for see images attach

CB installed on the passenger side, the unit is small enough that it won't be annoying for a passenger:
You must be registered for see images attach

Roof rack, front view:
You must be registered for see images attach

Roof rack, side view:
You must be registered for see images attach

Roof rack, top view (caps missing, have yet to buy them)
You must be registered for see images attach

Plastic looks bad but it's not as worse as it seems.

I finally reuse a Sportrack unit that I had from a previously owned car sitting in my dad's shed for three years. I think it looks great, almost like its OEM.

I plan on adding these safety caps:
You must be registered for see images attach

I should receive hub caps tomorrow and both the USB flushmount and Bluetooth OBDII this week.

I also ordered 1200 lumens fog light bulbs and another third brake light light bulb, red this time as I'm not that pleased with the current bulb result.

I thought about reusing the bulb (came in pair, tossed the other one in the console) for map lights (168) but I don't want them to dim when I drive. If I only change these two bulbs and leave the rest of the interior with standard bulbs, will the LEDs dim ? Also, they might be too large to fit in there even if the connector is the right one. Last but not least, it seems to be a PITA (from what I read) to get to the bulbs ? Need advices/direction on that one.

Thanks,
 
Last edited:

GeekFisher

Full Access Member
Joined
Jan 21, 2016
Messages
113
Reaction score
1
Location
Quebec
Still going on...
New hub caps:
You must be registered for see images attach

Roofrack bars holes capped! Will properly line them later.
You must be registered for see images attach

Blizzard warking, w/ flash
You must be registered for see images attach

Same without flash:
You must be registered for see images attach

Ready for blizzard comin'
You must be registered for see images attach
 
Last edited:

GeekFisher

Full Access Member
Joined
Jan 21, 2016
Messages
113
Reaction score
1
Location
Quebec
Reconnected the CB, installed the USB flushmount which was a PITA to do, still plastic trimming ;)
You must be registered for see images attach

Installed LED fogs:
You must be registered for see images attach

And a washed Jeep pic !:
You must be registered for see images attach
 

GeekFisher

Full Access Member
Joined
Jan 21, 2016
Messages
113
Reaction score
1
Location
Quebec
A few more:
You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach
 
Top