Search results

Hello there. Check the earthing points where the dash bolts to the body work they are behind the panel over the foot well they are on both sides of the dash. Also there is one below the battery holder behind the headlight. This does get corroded. I had a problem there and drilled it out , re...

Hello. Do you still have these with the wiring pigtails. If so how much to post to the UK. I will pay via PayPal. Cheers.John

Hello I have been looking into this one myself. Going to get some acrylic sheet to make some prototypes up.

Hello. I had most of the codes showing on my Crd Kj when I changed the engine and harness over. I would check the gateway module, which is located under the battery tray. Check the plug and check the mounting bracket for corrosion. I had to clean up the plug contacts and make a new bracket for...

Hello. I had most of the codes showing on my Crd Kj when I changed the engine and harness over. I would check the gateway module, which is located under the battery tray. Check the plug and check the mounting bracket for corrosion. I had to clean up the plug contacts and make a new bracket for...

Hello. I Installed one in my 2003 limited. It sounds a lot deeper on the bass as it should but not as low as a bassbox. You can get the wiring and installation instructions off the Just for Jeeps site it is under the electronics section on the 2002 to 2007 KJ liberty section.

Mine Sheared off before Christmas(2010) Made a mess of the Handbrake cables and fuel tank and rear axle wiring.All this on a public road. When It was removed it was showing signs of long term corrosion on the broken shaft pieces where the Ball joint is fixed to the axle. Our dealer network has...

Hi there I had the same problem in my 2003 CRD KJ. The sender unit float was sticking in the tank.I was going to install the Cummins/Dodge lift pump unit to cure it but I ended up swapping the tank to get it to fit as the 2003 model tank sender unit and head is different from later tanks.All...