Search results
-
What did you do to your jeep today?
Added a 20" light bar, plus fixed the droopy tilt steering by drilling through the clamps and putting a bolt through them. I also safety wired the lever in the up position (not shown).- Cactus
- Post #26,567
- Forum: KJ General Discussion
-
Lift pics and spec thread
Thanks! It drives SO MUCH better than the mushy sacked out OEM suspension. The Deeke UCAs didn't come with washers and seemed to fit about right. I did remove the 90 degree zerk fittings from the arm ends because they didn't look like they were going to fit in the recesses on the body. I...- Cactus
- Post #206
- Forum: Lift Kit Discussion
-
Lift pics and spec thread
BDS 2" kit with Bilstein front shocks and Deeke UCAs - 21" front, 21 3/8" rear.- Cactus
- Post #204
- Forum: Lift Kit Discussion
-
Vibration at 1500 RPM in Park
I've been chasing a vibration at 1500 rpm that occurs both in park and while driving (2003 sport, 3.7L). No codes. It runs fine at other rpms. I've looked at or replaced the obvious culprits, i.e. motor mounts, harmonic balancer, loose hoses, cooler lines, etc. I'm looking for other...- Cactus
- Thread
- Replies: 0
- Forum: KJ General Discussion
-
Sort of New to 4x4s...
Thank you! I will check it out today. Thanks for the advice! With the shifter in the 2H position I got underneath and pried the transfer case lever forward. This put the shifter in the 4H position. I'm not sure if I got your directions backward? Anyway, with the shifter in the 2H position...- Cactus
- Post #3
- Forum: Introductions
-
Sort of New to 4x4s...
Hi - just acquired a 2003 KJ Sport with 84 K miles that seems to be in pretty good shape. This is my first 4X4, but I do have a SXS and dirt bikes and am relatively mechanically competent. My first question is regarding shifting into the various modes vs what is indicated on the dash. This is...- Cactus
- Thread
- Replies: 4
- Forum: Introductions
