Search results
-
R
Need help ASAP
Ty for the reply I'm going to get a New sensor and see if this fixes the issue- RPG
- Post #8
- Forum: Introductions
-
R
Crank no Start
I'm taking about the reset of the throttle position sensor you do this by unhooking the battery for five mins then you turn the key to the opposition then you press the gas pedal slow down four seconds three seconds on the floor then three seconds then slowly up on the pedal four seconds and...- RPG
- Post #7
- Forum: KK General Discussion
-
R
Fifteen hundred and going
Have to take everything I can come up with still crank no start even here to submit starting fluid directly in the intake manifold nothing it didn't even attempt to fire up check all my wires pulled spark plugs dried spark plugs checked all the circuits all the wires still throwing the bad... -
R
Crank no Start
Yes sir I believe everything is right could this have happened when I did the reset with pedal wrong it put My Jeep into limp mode and if this is possible how do I bring it out of limp mode Ty for your relpys I really appreciate it I have a little over two grand in it thus far- RPG
- Post #5
- Forum: KK General Discussion
-
R
Crank no Start
Yes I sprayed cleaner and blew air through it I didn't replace it- RPG
- Post #4
- Forum: KK General Discussion
-
R
Crank no Start
Jeep was showing throttle body position sensor I did the reset with unhooking battery and the gas pedal I didn't do it the proper way Jeep Liberty will not start could the Jeep have went into limp mode- RPG
- Thread
- #jeepliberty 3.7 engine
- Replies: 9
- Forum: KK General Discussion
-
R
Need help ASAP
- RPG
- Post #4
- Forum: Introductions
-
R
Throttle pedal position sencer switch circuit A high
I'm watching deal on YouTube to reset my throttle position sensor in the steps I did it way longer than I was supposed to on each step now my Jeep won't start just turns over I've checked the fuel rail for the injectors eating fuel I drive the spark plugs out put them back in all it does is turn...- RPG
- Thread
- Replies: 0
- Forum: KK General Discussion
-
R
Need help ASAP
I'm working on a 2010 Jeep Liberty 3.7 I did the reset to the throttle body with the gas pedal I did it wrong now my car won't start just turns over code reader says throttle pedal position sensor switch A circuit high it was running ruff misfiring that's why I did the reset can anyone help me...- RPG
- Thread
- Replies: 8
- Forum: Introductions
