Search results

I followed a lot of this to do the job on my 06. On the smaller 10 mm bolts with washers, I found 8. 1 by the fan speed resistor, 1 below the airbag, 2 behind the stereo, 2 below the speedo, and 2 that are on either side of the column facing up. It was handy to have the airbag cover off to...

The flasher module was the solution in this case

I thought I would post to help anyone with this problem. My left blinker stopped working on my 2006 jeep liberty. It’s fairly well known that the flasher is inside the hazard button on this, and there is some YouTube videos on how change it. There is a relay for each direction inside the...

5000 mile update, seems ok and holding well as related to adding a little sealant on the outside of the gasket. By design it’s not supposed to have sealant but I had some pitting etc to deal with. I think the main point is to make sure sealant doesn’t squeeze to the inside of the gasket and...

Looks like this has been discussed slightly in other threads but I was having issue finding a good opinion. What is the best aftermarket radiator for 06 Jeep Liberty with external trans cooler and no Eng oil cooler? It seems mopar doesn’t make that one anymore. Thanks

Didn’t take long after fixing all of that, for my radiator to get a small leak on the front side of the upper hose inlet . When doing the pump I did the res tank, t stat, upper and lower hoses as preventive maintenance but of course the next one popped up now

I wasn’t having any overheating issues, just several trails of intermittent pink poking out around the pump face. The impeller on the one I took off was ok, I think was original. The new mopar pump was the same with plastic impeller. I figured this seeping would turn into leaking, and my...

Thanks. I did a tiny bead on outside of oring style gasket. I’ll report In a few months if I regret it. It seems if there are pits on the gasket surface, a little extra something may be needed, plus the fact I was re sealing seeps from the last time the jb weld pit filling was done at some...

Hi, I am doing a water pump this weekend. I encountered the pits on the surface. I have the jb weld setting up on the pits now. I have a new mopar pump with gasket. I really don’t want to do this again as long as I own the vehicle. I know it’s not supposed to have sealant but wondered if...

I just did this process on my daughters 06 liberty, and it was a nice relief to let the pump run to the end while not try to listen for the top of the fill approaching, to get the pump turned off before it spewed gas all down the side. I used a plug socket with a 1/4 inch extension fed into it...