Search results

Time to sell my Libby for something with a 3rd row. OME lift with Bilstein shocks. New radiator, water pump, most suspension bushings. She's a Freedom Edition so she has 17 inch wheels and I've added a few extras like the light bar and EVIC. The only thing she needs is the CV joint on the front...

Haha I've more time than money so i figure out cheap and odd ways to get stuff done.

You are correct sir, there's no way i was able to get a press in there but i was able to pry the center steel insert out with a heel bar. After that the old rubber kinda crumbled out with a screwdriver. Of course ymmv cause maybe i got lucky lol. The new Moogs just pushed in tho so that was a bonus.

The circled spot is the back of the electromagnet that clocks it properly. Also.......i really was able to replace my steering rack bushings without removing my rack lol i did remove tie rods and the steering shaft but it sure didn't take an hour lol more like 3 Haha. They were a pita to remove...

Forgot to add i didn't have to remove the compressor or loosen it but i did remove my electric fan. I didn't even think about doing a write up with proper pics sorry.

I bought a clutch kit from Ebay that cost me $38 and change. Came with everything shown but new. The clutch plate is held on by a locknut and you'll have to secure the clutch plate somehow. I used a 3/4 wrench to hold it in place. The clutch plate is just splined on the shaft so i used two...

This is what i did today.

This was interesting. I saw it yesterday when it wasn't on a Jack but he lost the bottom balljoint.

Lol you might be missing it. But i took care of it. I tightened up the backlash a bit and it brought the pattern in the tiniest bit. Thanks for actually looking and replying.

Need opinion on my pattern... do you guys think the pinion needs to come in more?

I changed these today. Rear upper control arm bushings. http://[url=https://postimg.cc/nsN7JxRY][/url]

Finally did something about the horrible reverse lights.

Finally got around to doing my steering rack bushings. Took me a few to figure out how to get mine out...not much room under there. I was able to extract the steel inserts from the rubber with my pry bar, then was able to pull out the rubber insulators. The new ones just pressed right in with...

no markings at all upon removal so probably cheapest ones available.

supposedly a year old. po changed them when I bought it.

this little guy snuck next to us while in the grocery

I did it I did it lol thanks for dumbing it down for me

she's a little lopsided, luckily she broke at home. broken ball joint. drivers side would have been right behind it.

I felt a little slop in the steering begin about a 1/4 mile from the house but I had just recently done the steering rack bushing fix and I just figured I had to tighten it up or something. I'll post some pics one I figure out how to use the img tags lol

so after pulling into my driveway and straightening the wheels...my passenger lower balljoint decided to let go. pita but upon further thought...at least it didn't let go doing 75 mph on the freeway. I decided to pull the drivers side as well and it was dry as a bone so maybe the whole incident...