Search results
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Ok so I'm getting the P0523 code which says: P0523 Jeep - Engine Oil Pressure Sensor/Switch Circuit High Voltage Repair Importance Level: 3/3 Repair Difficulty Level: 3/3 What does this mean? Possible causes - Low oil level or motor mechanical fault - Faulty Oil Pressure sensor - Oil Pressure...- Bp.designs
- Post #17
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
I haven't tried the key trick yet but when I get off work I will. I did however remove and check ALL 6 plugs for spark by laying each one individually/one at a time on the head(aka grounding them) and turning it over. Each has strong spark. Also side note when I removed each one it was wet with gas.- Bp.designs
- Post #16
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Well the cam sensor looks good but is there a way to check it?- Bp.designs
- Post #13
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Video 2 https://youtu.be/7kF0jULrTig- Bp.designs
- Post #12
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Quick video 1 of 2 https://m.youtube.com/watch?feature=youtu.be&v=l2sHKfO3qWY- Bp.designs
- Post #11
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Hey thanks for the link, I will try the key codes trick when I get off work today. Every bit of help is great so thanks so much. I have done a rebuild very similar to my 99 f-150 and so the physical rebuild wasn't too bad, but the electronics are a bit different. Wish the electrical was as easy...- Bp.designs
- Post #10
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
I have not cleared/reset the codes. I'm not sure exactly where the PDC or ASd is though. I'll do some research. Thanks for the suggestions :)- Bp.designs
- Post #7
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Ok, so the cylinder 2 valve seat pulled out(was told very common on the Chrysler 3.7 by the head shop) and so I had the valves and heads rebuilt. I replaced all the gaskets, plugs, oil, filters, fluids and fan shroud. Basically the only thing I didn't touch was th primary timing chain and both...- Bp.designs
- Post #5
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Yes I did. :)- Bp.designs
- Post #3
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Hey all! So here's the low down... I just finished putting everything back together on my wife's 2002 liberty sport. It's getting spark to both banks and fuel as well. When I tore the engine apart I did not replace any of the timing chains. Before removing any cams I sent everything to top dead...- Bp.designs
- Post #12
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Yes thanks so much!- Bp.designs
- Post #11
- Forum: KJ General Discussion
-
B
Just rebuilt 2002 3.7 Liberty sport and won't start :(
Hey all! So here's the low down... I just finished putting everything back together on my wife's 2002 liberty sport. It's getting spark to both banks and fuel as well. When I tore the engine apart I did not replace any of the timing chains. Before removing any cams I sent everything to top...- Bp.designs
- Thread
- Replies: 17
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Well thanks so much gyro and dude 1116!!! Found the knock sensor and plug it in! All that's left to do is fill it up with coolant and try to start er up!!- Bp.designs
- Post #7
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Gyro Thanks so much! Anyway I could grab that pdf manual from ya?- Bp.designs
- Post #5
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Here is a quick video of the plug location https://youtu.be/Lz7yQ86Ezp4- Bp.designs
- Post #3
- Forum: KJ General Discussion
-
B
Jeep Liberty 3.7 plug connector???
Ok, so I'm new to the forum, but I have been rebuilding my wife's 02 Jeep Liberty Sport because her cylinder 2 valve seat came out. After rebuilding the valves and heads and putting everything back together I have one plug nearest to the firewall on the left(drivers) side harness that I cannot...- Bp.designs
- Thread
- Replies: 11
- Forum: KJ General Discussion
