Search results

  1. Ian

    ARB Bumper weight

    ..
  2. Ian

    ARB Bumper weight

    I have arb and 9500 mile marker winch. Steel cable and lights. No noticeable drop. I can sit on it and it doesn't move either. I'm 170lbs. Your good.
  3. Ian

    What did you do to your jeep today?

    No, that was the bypass. I was trying to ride the high side to stay out of the ruts that I was sure to bottom out in. That is one tire in the rut. Back tire is almost 3' off the ground. There was a lot of s**t talk by the bronco guys when we first got there, but that ended very shorty after the...
  4. Ian

    What did you do to your jeep today?

    Sent from my XT1080 using Tapatalk
  5. Ian

    What did you do to your jeep today?

    Sent from my XT1080 using Tapatalk
  6. Ian

    What did you do to your jeep today?

    Took the Libby out to Elbe WA for a day off road. It did very well and took me everywhere I wanted to go, with the help of the 9500lb mile marker up front on one occasion, which you can guess which occasion in the pics. :confused: Sent from my XT1080 using Tapatalk
  7. Ian

    Cat delete.

    What he said. I run a cat back magnaflow. Sent from my XT1080 using Tapatalk
  8. Ian

    What did you do to your jeep today?

    I installed the OTIS today. Went to the junk yard and ripped apart a 99 intrepid. I took the time to trace the wires back all the way down the a pillar and cut the wire harness apart so I had enough write that I did not have to add any. While I was there I went ahead and pulled the ambient temp...
  9. Ian

    What did you do to your jeep today?

    I thought about going under the seat but we have so many rigs out here running them you have to change the channel often. Sent from my XT1080 using Tapatalk
  10. Ian

    What did you do to your jeep today?

    I drove it rite after the install and I had no issues with it. I ended up just laying the mic across the steering column because I wanted the cable away from my legs, and I don't much like the look of the mount when its right in the middle of the dash. I'm hoping the signal will be good with...
  11. Ian

    What did you do to your jeep today?

    Its dark, so they arent the best pictures, but here ya go.
  12. Ian

    What did you do to your jeep today?

    Installed the CB and mounted the Firestick antenna. Doesnt look too bad mounted to the ARB front winch bumper.
  13. Ian

    Electrical Problems P1491 and P1682

    What Is yours in the shop for? Sent from my XT1080 using Tapatalk
  14. Ian

    Sway bar Disconnects?

    Yes a LSD is defiantly on the list. I wheel with, JK's and I sometimes have my work cut out for me trying to follow their line with there SFA and sway bar disconnects.
  15. Ian

    Sway bar Disconnects?

    I have a 02 Liberty sport with a franken 2.5" lift and Jeepin by Als upper control arms. I have amazing articulation with the rear axle, but the front end is just not the case. Has anyone ever installed a sway bar quick disconnect on the IFS and if so, what were the results? It is driven on the...
  16. Ian

    Electrical Problems P1491 and P1682

    I replaced the alternator and the Radiator Fan Relay and the Jeep is as good as new. ALL the problems are now resolved. The KJ is running great. Thanks mostly to you guys here on the forum, oh and the Mopar service manual. ;P
  17. Ian

    Electrical Problems P1491 and P1682

    This is my story exactly. Only I do not have the p1682 code. I am planning on doing the alternator and the radiator fan relay both tomorrow, but should i just do the alternator for starters?
  18. Ian

    Ahhhhh!!!!electrical!

    Here is today's update. I pulled the alternator and had it tested, which it passed. After reinstalling it i put the volt meter to it and i was getting 13.5v. I also cleared the code for the check engine light after reinstalling the alternator. I did get the check light again so i ordered the...
  19. Ian

    Ahhhhh!!!!electrical!

    Thanks! I absolutely love this rig and it is so much fun to drive. I think I need a transfer case position switch as well because my part time light will occasionally come on when in 2wd and if I touch the selector it will go out. It never actually comes on when in 4wd. 4 low light works as it...
  20. Ian

    Ahhhhh!!!!electrical!

    I'm a brand new kj owner and I must say I am completely hooked! I absolutely love the rig. My 02' kj has a Franken lift kit, ARB shocks, magnaflow exhaust, arb bull bar and 9500 winch and kc lights on it now. The problem i am having is I have a check engine light code p1491 which is radiator...
Top