The 3.7 V6 engine has two camshafts & has rocker arms but no pushrods . The lobes on the camshafts work the rocker arms which in turn work the valves .
I still think the oil that ran out is the key to this engines problems . Unless a broken timing chain caused an oil leak in the timing chain...
I still think you should slide under the engine with a good flashlight & look at both sides of the block above the oil pan as best you can . In the general vicinity of where the motor mounts bolt on . Oil running out , engine only turning a partial revolution , sounding more & more like a broken...
It won't hurt anything to turn it with the plugs in . If the engine is already damaged internally you'll likely have trouble trying to turn it . Only getting a click when you turn the key means either proper voltage isn't getting to the starter , the starter itself is bad or the engine is seized...
Pulling the plugs will make the engine easier to turn but unless it's seized you should be able to turn it with the plugs in . Is the oil leak you have significant , a lot of oil anywhere or just a few drops ? Puddle under the vehicle ? I'm curious why the tow guy seemed to think the engine is...
53013592ac indicator-transmission fluid level (chrysler)
This is on ebay for about $15.00 & says it fits jeep liberty & it's yellow , there's at least one more on there too .
I'd get under it with a light to determine where the oil is leaking from . If a rod knocked a hole in the block or there's a hole or holes in the oil pan the engine is junk . If the leak is something simpler I'd get a breaker bar & a socket & try turning the engine by hand .
If I remember...
A couple months ago I bought one off ebay from the same company . The first one they sent me had a dead injector driver . I returned it & they sent me another one which seems to be working fine .
When I bought mine it said that their lifetime warranty was good for one return / refund then the...
Thanks guys , I have a parts jeep with low mileage & I removed the pump & hoses from it . The wrenches felt a little loose on it too , but worked . I haven't swapped the parts yet but will soon .
Swapped the parts this afternoon , 18 mm slipped on connectors at rack , had to use a cresent...
2005 3.7 Liberty .
Power steering hose that loops behind headlight has slight leak & once there was a decent sized puddle on my driveway . Not leaking at threaded end connections .
Did a forum search & found some say a weep is common , is above what was being referred to ?
Also found threaded...
2005 3.7 Liberty . I ordered new boots for both ends of the front driveshaft . Both joints were still full of grease , tight & didn't appear worn . I replaced the boot on the transfer case end , no problem . On the differential end the joint came apart & the 6 bearings fell out .
I replaced...
Swapped engines in my Liberty & now radio doesn't work . From what I've read I need a code to reset it . I don't have the owners manual . Has anyone called a dealership & got this code from them ?
2005 Jeep Liberty 3.7 V6 .
A couple of the plastic injector wire connectors have the piece you depress to release the connector from the injector broken . I have a spare wiring harness that I can remove these plastic connectors from if they can be removed .
Is there a way to remove the wires...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.