Cruise Control light comes on, Cruise Control worked this morning, not it will not set or engage.
Ran the code check and I'm getting P0837 and P0838. This points to the 4wheel drive sensor. I guess I am correct in thinking this would cause the Cruise to fail to engage?
Any quick way of...
So I figured out that you can slide the socket for the Map lights out by pushing them to the side and down which allowed me to get to the bulbs and put in LEDS. I replaced the Map lights, the passanger floor light and cargo light.
Testing shows all lights dim and turn off as expected. I...
The "rust" color is probably just dried up HOAT. It is very important to NEVER mix antifreeze versions. HOAT, OAT and of course DEX and anything green. You are unlikely to get rust in the radiator, no steel in there that I know of. The more likely issue is clogs due to jelly.
I had mine...
02 Liberty with EVIC and push button dome/map lights. I have the unit out and there are two push in type bulbs however I cannot figure out how the heck I am supposed to get a finger in the reflector to pull them out.
The objective was to replace them with LED's but I am now reading that...
ok so is your fluid Green or pink? If it's green, your screwed. The shop put in the wrong stuff and you likely have jelly all through your system.
If it's pink then let's move on:
- As far as I know all Liberty's of that year had both a belt driven fan and electric fan if equiped with the...
Was trying to find any type of storage solution for the rear cargo area and was very disappointed that even this late after the KJ platform introduction I can't find a thing.
I did find on another forum where an owner built out a fairly decent system but to be honest I'd rather not build and...
Granted my Liberty is an 02 and that's a lot of years of sucking air but I was surprised how thick it was on there considering how far up in the dash it is. It shouldn't be sucking a ton of carpet fibers and generally I don't have the windows down except for a few weeks in the spring and summer...
I have had a heck of a time with low air movement from the vents when the A/C was on re-circulating air and I suspect when on heat as well. Everyone wanted to blame various mechanical issues, many of which could cost hundreds of dollars but I fixed my problem in 10 mins and no tools.
In my...
Solution Found!
After searching the Internet for years, asking questions for years and everyone always going for the worse case of dead A/C, broken vacuum lines to who knows what else I was able to fix my problem in less than 10 minutes today.
In my search for answers I found the following...
Which was likely the case however after the radiator was replaced and they said they flushed everything I should not have continued getting such jelly. When the engine was replaced I was able to look inside and in the engine cavities the slime was more condensed, almost a paste.
The original...
No there used to be a lot more air on re-circulating than now but it has been years.
Engine was just replaced by a dealership (only because I get a labor deal) so I know they would have noticed a disconnected hose and fixed that and would hope they would have noticed a really bad one plus if...
This has been going on for several years and I just deal with it however I just spent a ton on a new engine so I'm in the mood to get everything working right.
A/C on outside air blows like mad through the vents. When you put it on recirculating air 90% of the air is dumped into the dash, not...
So I have asked in a number of forums about the design of the heater core but have never gotten an answer.
I like most have had poor heat in my older Liberty. Everyone says replace the heater core, even the dealer, however when I state that when I back flush the core I am able to get a full...
So going to divert this thread just a touch since the posters were active on this topic.
I've had multiple techs swear all my frontend noise if tire based however I just can't agree with this. I have the whirrr, whirr at 35-50 MPH with a slightly different noise which is a lot less loud at...
So I just had my 02 engine replaced with a rebuilt engine. The idle is a bit rough for what I think it should be. Is this a computer issue with an old 02 computer and possibly newer engine?
So digging deeper there are no "spark plug wires" but a spark plug coil adapter. Really screwy some auto parts places do list a wire set.
Is there any difference in these coil plugs?
After making post about noises and so forth on my Liberty it took and dropped a rod a few weeks later. As my Liberty is in perfect shape inside and out I decided to get a engine replacement and I'm rounding up the extra parts needed by the mechanic.
One thing I had trouble finding was a water...
I had seen it or similar which is why I mentioned the key switch pin. Played around with the ignition some today and there is no slop or wiggle in any position. Of course Jeep started up on each test today.
I would think if this is a problem with the ignition switch assembly then once it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.