Recent content by Weaver

Anyone running these? Need to upgrade my current tires

178,000 km

She's going in the shop in about a week to fix a coolant leak so I'm gonna have them give it the once over. Hopefully we can figure this out

I have a capacitor and it was showing about 12.2V when off and 14.5 when running. I'll try to clarify. "Won't start up and still won't turn over" = I can hear the engine starting to make noise but then it dies (almost like it's not getting fuel). It's not like it's completely dead with only...

Rougly 700$ for parts to regear ?

K thanks. Thinking about a set of Open Country c/t So I'd have to regear with 24-75-16s?

What tires can you typically get in there after the lift ? 32s?

Do you NEED to get the upper control arms with an iroman 1.5" lfit?

Hey guy I've got an 05 3.7L that has an ongoing issue. It cold starts perfectly but if I go somewhere, shut if off then try to start it up a couple minutes later it wont turn over on the first try but does on the second try. So yesterday I had been driving around a bit then I run into the mall...

Would the fuel pump have anything to do with it? Should I turn it for a few seconds then try and turn it over. Thanks I just want to get this figured out.

Hmmm well I'm not calling you a liar but if I dont pump it it kinda runs then dies, and then starts fine the second time. Any ideas what to do with it?

Hey so this happens randomly, it will start fine the first time (cold start in the morning) but if I try to start it up shortly after running it around it will spit and sputter and not start up (unless I pump the gas a little). But if I don't pump the gas and try it a second time it starts up...

@hecktikart look into the big 3 that might solve your dimming issue. My setup: Alpine CDA 9886 deck Polk Audio MM6501 6.5 components Kaption Audio 6.5 reference components Kaption Audio D1000 Amp MB Quart ONX 4.125 Amp 1 Farad Cap 2 12" Kaption SPL subs It's like a mobile...

Edit: Title should be new amp and speakers! Bought a new 1000Wrms/4channel amp (MB Quart Onyx 4.125) and Polk audio mm6501 components. Currently have kaption coaxials in the rear and kaption reference components in the front, will be removing the coxials and moving the fronts to the rear...

I did a little poking around anyways aha I was bored at work, but for your budget Id reccomend Polk Audio DB651. You can get them for around 50-60 $ on amazon, they are coaxials so you can just plug them into the existing wiring n they dont need to be ampd, the stock speakers might have a little...