Recent content by uctke283

Rear Brake pads and Rotors.

bummer - I hate the LIE too....

I have had the BDS kit too, but only for a month so far - I have to say that it is very well built - they have a great Warranty if needed and was easy to install... My front was at 19" before install and 23 after install -that is with no additional spacers or clevis lift.

The fronts will be the stock length, in other words, 0" lift. The rears are to be longer....

They are intact and dry - I think I will pull the CV's and check them for wear.

rotational, not while turning. no popping sound, just a thumping...

so I pulled the front drive shaft and I still have the noise, so I am now thinking front wheel hub/bearings? I have tightened every bolt including brake calipers that I touched in the last month or so. The sound seems to stop when I touch brakes, but I can hear it all speeds..

never mind I got it with the tap of a hammer.

so what is the trick to getting the old shaft out? I cant get the front end out of the caseing...

I can partially rotate it both front and rear, it appears that most of the play is towards the front, but there is some at the back.

I just sent you an email.

I hear a thumping noise when driving - no vbration or feeling in steering wheel. It feels like it is coming from under the center of the jeep. I went under and I have some play back and forth, and I can also rotate it about 1/2 inch or so. Does this sound right? I am assuming I can remove...

Lift is done!

I agree - the alignment shop couldn't fit me in until Wednesday -