u2slow's latest activity
-
u2slow reacted to KJowner's post in the thread Six speed Manual Trans fluid exchange time/mileage schedule with
Like.
I wouldn't stress too much, long term get a new plug and weld a nut onto the old one (or get a garage to do it) so it can be removed. -
u2slow replied to the thread 2003 rear diff posi.I would not bother taking it further apart, and leave the additive out. After test driving it to get the oil circulated and warm, THEN...
-
u2slow replied to the thread My rear springs on the 2002 kj keep popping off when I'm fully flexed out. I'll post pics below. What can I do to fix this issue . Thanks everyone..Stock shocks would limit travel. Extended shocks may do what OP is experiencing. I'm running 4runner coils... they are longer, but not...
-
u2slow replied to the thread 2" Spacer Lift, TPMS ??.That seems a more likely culprit.
-
u2slow replied to the thread 2" Spacer Lift, TPMS ??.Can't imagine how 2" of lift can mess with TPMS... think you have an odd coincidence going on. Who did the install? Was the battery...
-
u2slow replied to the thread 2004 KJ radiator replacement - no side/circular bushings to swap out?.Quite sure I had to swap them over from the old rad. I also seem to recall seeing these bushings on other Chrysler products - can't be...
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..No they weren't. I think that's the very last time I bought a Moog bushing or joint.
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..My invoice from 2016 says I ordered 2 units. Don't recall having any extras. Good luck
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..Each. One per box. I will never buy them again. I got a whole arm from rockauto for $74. Amazon wasn't far off that price either.
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..Moog K200428 Mine were from rockauto, and they still have them.
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the...
-
u2slow reacted to duderz7's post in the thread Rear upper control arm wont go in all the way with Like.
Remove bracket from axle, insert ball joint, reattach bracket to axle.
-
u2slow replied to the thread Suggestions for A/C clutch?.Yes. Both original Mopar.
-
u2slow replied to the thread Suggestions for A/C clutch?.The swapped-over front clutch plate seemed to work initially, but 2-3hrs down the highway it was smoking and subsequently killed the...
