Shankster's latest activity
-
Shankster replied to the thread Dexron and transmission delay.I would NOT do that. On the recommendation of a friend I once did the same thing to the family minivan and the transmission failed a... -
Shankster replied to the thread Dexron and transmission delay.I would consider that negligence on the part of the shop. Betting they just didn't have the right fluid on hand so gave you what they...
-
Shankster replied to the thread Outer Tie Rod End Contacting Sway Bar on 05 KJ 3in Lift.I have not - I seem to have very good clearance with a similar lift. Can you include photos? Seems unusual, like something is upside...
-
Shankster replied to the thread Rattle noise in gear..Hopefully it healed itself?:)
-
Shankster replied to the thread '05 Sport: What to do....I don't think I'd invest that much in putting in a used engine. Whatever you find will likely have over 100k miles - might go another...
-
Shankster replied to the thread Rattle noise in gear..So when you take your foot off the brake and start moving does it continue or go away? I think I'd get an assistant to be in the...
-
Shankster replied to the thread Over tightened Pinion Nut.If I were you that's what I would try first - get a new crush sleeve and install it and hope that does the trick. I used a little 1/4"...
-
Shankster replied to the thread Where's the evap Vent valve???.That would be great news if it was all just caused by a loose connection. I guess you'll still need to get rid of that CEL for your...
-
Shankster replied to the thread Cold Start fine but Warmed up it struggles. Vapor lock or CPS?.No check engine light? No codes? I had an 89 Mustang that did exactly what you're describing and it turned out to be a bad fuel pump so...
-
Shankster replied to the thread Where's the evap Vent valve???.If it was your PCM there are services out there that can fix it - I've never done that but it doesn't look to be super expensive...
-
Shankster replied to the thread Where's the evap Vent valve???.I guess the sound could be the fuel pump then. Doesn't necessarily mean it's bad though. The fact that it stays on a while after you've...
-
Shankster replied to the thread Where's the evap Vent valve???.That is weird. I wonder if that points to a bad PCM? I recon you should always be able to reset a CEL, at least until you fire up the...
-
Shankster replied to the thread Where's the evap Vent valve???.Hmm, dunno. As far as the sound it sure sounds like a pump of sorts and the only pumps back there I can think of would be the fuel pump...
-
Shankster replied to the thread Where's the evap Vent valve???.Those hoses actually look pretty good - a lot better than mine were. Are there any cracks in them?
-
Shankster replied to the thread Where's the evap Vent valve???.I just replied to your other post. That's the leak detection valve in the middle photo. Not sure what you mean by vent valve - isn't...
