Recent content by projectkj

at 8:45 you can see he bashes on the drive shaft yoke in order to seat the U-Joint, if you hit to hard you will bend the two yokes together

i wouldnt use a hammer to take them out....(if anything to take them out, and bring the new ujoint to a shop to press it in... DO HALF THE WORK AND pay for half i did mine and used a press.. i mean the hammer is cheap and most people have. If you miss you can damage the drive shaft......

come make my engine bay look like that.. mine looks like a mud puddle threw up all over everything

well i guess its not what i did today (as its 10am and no way i did this all in 2 hours) but oil leak on driveway after a 2 hour drive last week (friday), rear main seal was gone. This only 7 months after putting in a 80,000km motor in (in hind sight i shuld have done it then, but 7months ago i...

l got a little sick of the stock rims on the liberty and want to eliminate the steel wheels... although i do offroad a fair bit, the stock rims served their purpose. but just on the inside of the stock rim is a 1" grove that collects alot of mud 2-3 lbs of mud, and greatly throws the balance...

found out i have a crack in the rad, not a huge leak.. but ordered a new rad.. so again jeep is down for the count.. dont want to damage my newly swapped motor

not sure if air bag works, but with a bump like this i am not going to be the one who needs attention after i hit something.... JK bumper will work with enough time and fabrication.... bit the mounts have to be roughly 5-6" from the stock from frame..

not today, but went away with a few friends, took the tent trailer hit the trail for 6 hours...waiting on pictures / videos from other peoples phone... truck was awesome, climbed some awesome ledges, went through some nasty holes.... only problem was a bolt on strut town apparently came loose...

i didnt want to loose fogs (YET), but as i found out i need MARKER lights at the front, i may have to try and find some that fit in that spot.. then i will wire my last 10" LED bar to the BULL bar on my fog light circuit.. 1 x 10" bar has less draw that 2 incandescent bulbs on the fog circuit now

i dont think you would get a big vibration on the wheel bearing.. would sound like metal on metal grinding....

YES (cringes like you may or may not like them) they are not as noticeable to oncoming traffic as i thought.. plus i need to add orange LED's that stay on all the time as clearance/marker lights

oh almost forgot took my liberty after fixing valve cover leak to go get some beer and a prescription, got a compliment on my bumper and light bar.....finally washed out the mud in my steel wheels from about a month ago, many its nice to have balanced wheels ****do not panic this will not be...

thank you everyone else for the support... all i did was share a picture of what i have done today, and started my own post about what i have "FABRICATED" in the other section.... a private message would have been much easier....

all done....

painted front grille black, and added the BULL bar