Recent content by nohitter64
-
Passenger Side (right side) Axle doesn't seem to be in all the way
Not sure if this is the same issue but when I lifted mine, I recall they shortened the axles to accommodate the new angle. Years later, the boot tore and the mechanic replaced the axle...it kept popping out and I had to remind him that we shortened the axle previously. We kept the old and just...- nohitter64
- Post #7
- Forum: KJ General Discussion
-
Rear window switch
Yes, that isbhow it appears to work. Open the door and remove the interior plastic panel. I took the entire thing off instead of the little cut out. Remove a couple of bolts (or nuts...it has been a while) from the interior of the door to permit the handle to rock outward. On the back you can...- nohitter64
- Post #8
- Forum: KJ General Discussion
-
Rear window switch
I was able to remove the pull handle on the door. One of the wires corroded off the contact point so I clipped/ cleaned the end and soldered it back in place. Took about an hour and solved the issue.- nohitter64
- Post #6
- Forum: KJ General Discussion
-
2016 Liberty Radio Replacement
I went to the Crutchfield website and ordered a Sony stereo with Bluetooth capabilities and sony speakers. Works great.- nohitter64
- Post #2
- Forum: Electronics
-
2004 Jeep Liberty Sport with GXMP Remote Keyless Entry
FWIW, on my 2006, I had 4 keys with integral fobs and 2 keys with chips programmed at the same time. I thought I read 10 was the max somewhere...- nohitter64
- Post #4
- Forum: KJ General Discussion
-
AC refrigerant leaking from black tube after being charged
I used the articles on this forum in the How To. I recommend zip lock bags and a marker. When I remove a "type A" screw, I wrote "A" next to the hole on the dash.- nohitter64
- Post #17
- Forum: KJ General Discussion
-
AC refrigerant leaking from black tube after being charged
Where does this hose belong? I found it in my yard and wondered what it was...must have come off pulling my trailer.- nohitter64
- Post #16
- Forum: KJ General Discussion
-
What did you do to your jeep today?
A classic..- nohitter64
- Post #26,037
- Forum: KJ General Discussion
-
Fuel can side panel carrier
Love it...well thought out. Added to my list...cheers!- nohitter64
- Post #5
- Forum: KJ General Discussion
-
Fuel can side panel carrier
That looks great. Been thinking of doing something similar to blank the window. Curious, did you use 18 gauge steel?- nohitter64
- Post #3
- Forum: KJ General Discussion
-
What did you do to your jeep today?
And you avoided the Jersey Devil...well done.- nohitter64
- Post #25,979
- Forum: KJ General Discussion
-
KJ general reliability information
I purchased an '06 in 2011. Have 208k miles on it and going strong. Aside from the rust on the rockers mentioned above, check the coolant. It should NOT be green as these rigs need HOAT. Window regulators break..but it's the plastic bracket that holds the glass not the motor most times. You can...- nohitter64
- Post #7
- Forum: KJ General Discussion
-
ATV Hitch Hauler
I am curious, has anyone ever used or witness the use of one of these hitch haulers for an ATV? http://www.versahaul.com/vh90.php My WK2 is rated to 650 tongue weight so I was wondering... Hope you all had a Merry Christmas and Happy Holidays!- nohitter64
- Thread
- Replies: 1
- Forum: KJ General Discussion
-
What did you do to your jeep today?
The second time I replaced mine I used the Sebring one. Has lasted longer than the one from the dealership.- nohitter64
- Post #25,231
- Forum: KJ General Discussion
-
Front Drive Axle
Thanks! I'm sure I'll have more questions as I get into it.- nohitter64
- Post #5
- Forum: KJ General Discussion
