Recent content by Liberty For All

Brighter LED bulbs first, then you can buy a short LED bar that can be fixed onto the top of the front bumper between the headlights.

I use steel wheels from 4WheelDriveParts online. I recall they may be 3/4inch offset and they look great.

TY, Excellent description of the procedure. Now, in 2023, this Senior on a fixed income will have the confidence to do mine on my 2005. I guess eyeball the adjusting after the install? Spinn the wheel so it does not drag?

I bought my tow hooks from the dealer back in 2005. I recall they came with the hardened bolts and nuts that spread out as you turn the bolts into the frame. Not sure the rating of the bolts so ask JEEP at their phone number and if they don't make them at least you will know which bolts to buy...

My rails came as advertised by RRO, but I had to add rubber strips below each foot of the rails to avoid metal to metal contact. One of the rear bolt holes on one rail was a little off center which I called to tell them to check their measurements. Also, I have a little rust where the welds are...

With a helper do you run the engine while he presses the pedal or can this be done with the engine off??

I had my curved flywheel resurfaced when I had my clutch replaced on my 2005 gasser, Six speed.

I had my flywheel resurfaced on my 2005 Six speed when I had my clutch replaced gasser and it was curved.

Yes, owned my 2005 since new and have learned how to place my feet to avoid the crowded peddles. I have a clutch too. I am extra careful if I am wearing boots.

My 2005 Driver Side Seat Belt is worn out. Would there be any issue swapping it with my Passenger Side Seat Belt? Has anyone done this? If so needed, where would I buy a new belt?

I had installed a hitch many years ago and took it to my dealership when notified of the recall. They said I was good as was and I asked for money that I had spent on mine. Dealership refused but I called my local TV News Station Consumer Reporter and she had Chrysler headquarters send me a check.

I own an 2005 and had a clutch replacement three years ago. I left my KJ overnight and the shop said they had a local machine shop carefully refinish the Flywheel. I asked the machine ship guy and he knew it was curved. He claims he very carefully turned the Flywheel taking minimal surface off...

Those are for if you have an Automatic Trans. When I replaced the radiator on my 2005 just let those be. I have a manual trans.

I have some grease fitted OMIX brand LBJs I will be installing from 4 Wheel Drive Parts. Hope they do well. I had the current LBJs replaced under the recall years ago but they were the same non grease OE that were originally there. No improvement.