lfhoward's latest activity
-
lfhoward replied to the thread Broken sway bar link bolt.Reporting in… I broke it again!!! Here are the two nuts I was using as jam nuts. Well that didn’t work. Well it worked a little. I... -
-
lfhoward reacted to joooooooooop's post in the thread What did you do to your jeep today? with
Like.
First off road test. Was surprised how well it did with open diffs, traction control seemed to work well. -
The sway bar does not interfere with the lift. The vehicle handles better in higher speed maneuvers with the sway bar in service. I...
-
lfhoward replied to the thread What did you do to your jeep today?.Oil change today, and topped off the radiator coolant. Mileage is 228166. I needed a break from that broken bolt in the frame that has...
-
lfhoward replied to the thread What did you do to your jeep today?.Look at those shiny new coils!!!
-
lfhoward reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with Like.
New plugs and coils are in!
-
Or just some old car guy with a mill in his hobby shop. $80 cash.
-
lfhoward replied to the thread Broken sway bar link bolt.Just ordered a magnetic induction heater! It arrived this afternoon and I’ll try it out tomorrow. This I think is maybe the best option...
-
Can you get a stud remover on the bolt thats left? Or perhaps one of the electric coils that heat up the broken bolt? Both can work...
-
With how close those lines are I'd rather weld a nut on than blast a blow lamp in there, the welder will only heat the broken stub up.
-
lfhoward replied to the thread Broken sway bar link bolt.Welding a nut on will be my plan B if heat doesn’t work. But hoping it will!
-
Just make a shield from crumpled tinfoil for the lines, they are several inches away so it's only sparks you need to worry about (** as...
-
Perhaps a friend with a portable oxy/acetylene setup could get it hot enough. Dont neglect the old warm bolt melted crayon trick...
-
At worst it’s probably a $5 experiment, including a can of butane that will last you forever. ;) It worked on my rusty brake line...
-
There isn't any MAPP gas left, it was discontinued years ago and the MAP Pro isn't what MAPP was
Latest posts
-
-
Can I get an alignment before rear control arm replacement?- Latest: GitEmSteveDave
-
-
-