KJowner's latest activity
-
KJowner replied to the thread CRD mechanic.Is it running OK? Using oil or coolant? Might be something as simple as a sticky EGR -
KJowner replied to the thread Transmission limp mode, 2.8crd 2006.Looks like the TCM may be faulty. Or the wiring harness?
-
7 bolts in total. 3 on top. 3 on the door side, 1 is under the rocker molding 05-07. 1 on the front lower under the bumper skin. Gyro
-
KJowner replied to the thread REAR LOCKER FOR 06 KJ CRD C8.25 WITH C-CLIPS.Check it first, a lot of the export CRDs had an LSD as standard. Jack up both rear wheels and spin one, if the opposite wheel spins the...
-
I sussed out the last bits of my manual transmission Master and Clutch slave uograde/replacement. Long story short - I hate the 'lubed...
-
That's very helpful I'll check it out tomorrow, Thank you
-
No programming needed it was plug and play. Just like the cruise control I installed last week.
-
Got shipped the wrong part for my strut rehab project … Grrr. I won’t be doing that this weekend, I guess.
-
Some of the programming stuff isn’t too bad if you have the wire harness in there already. I was able to add automatic headlights to my...
-
KJowner replied to the thread 2006 kj crd rear 8.25 diff c clips.They all use the US made 8.25, a CRD would eat a D30.
-
The Chrysler 8.25" is a c-clip axle. Is this an outside-north-america production Jeep? If so, I can't guarantee these use the 8.25".
-
I would suspect they are like the other 8.25's, so yes.
-
KJowner replied to the thread What did you do to your jeep today?.I did my headlights with 2k clear lacquer, they were almost opaque, after a quick wet sand and a wash with alcohol I put 3 coats on wet...
-
Not too bad actually!
-
Scored a fog light kit at a junkyard. $40 total. Lenses just need restoring.
