KJowner's latest activity
-
Well, i errored. I have a LIBERTY and these were from a Patriot! So, the center hole was 67.1MM and mine was 71.5! NO fit, SO, I made a... -
Or just some old car guy with a mill in his hobby shop. $80 cash.
-
KJowner replied to the thread Broken sway bar link bolt.With how close those lines are I'd rather weld a nut on than blast a blow lamp in there, the welder will only heat the broken stub up.
-
Beware there are different gaskets for the metal vs plastic rocker covers. Timing cover, oil pan, and various sensors can leak also. I...
-
KJowner replied to the thread Bulb keeps burning out and breaking, anyone know why?.Vibration is a killer, try an LED and make sure the holder isn't loose.
-
KJowner replied to the thread Transmission oil cooler size.It depends how much comes out of the guts of the gearbox and cooling pipework. I think a total fill from dry is something like 11 lts.
-
The H&R lift springs are a good option if you don't want to spend as much as an OME setup. Will give you 1.5" of lift.
-
KJowner replied to the thread Belt tensioner >> stripped@@*.* << mounting bracket.As far as I know both of mine are original, I'll see if I can find a picture on my phone, I'm away at the moment. INA or Dayco are good...
-
-
KJowner reacted to LadyLiberty¹'s post in the thread Belt tensioner >> stripped@@*.* << mounting bracket with
Like.
Thx for the idle pulley tip! ~Saved -
KJowner reacted to LadyLiberty¹'s post in the thread Belt tensioner >> stripped@@*.* << mounting bracket with Like.
I meant the whole belt tensioner...the ones I bought have had a lame spring that outlast the bearing. Found one on Amazon with a 5yr...
-
KJowner replied to the thread Broken sway bar link bolt.Just make a shield from crumpled tinfoil for the lines, they are several inches away so it's only sparks you need to worry about (** as...
-
I mean, it runs without issues most of the time- I’m getting P0344 either right after start or within first couple of minutes of...
-
KJowner reacted to Patrick McGrinder's post in the thread Manifold Absolute Pressure Sensor Connector with Like.
I did it yesterday and it took a while but it worked.
-
KJowner replied to the thread Sensor issues.I doubt multiple sensors are faulty, have you checked the plug and wiring?
