Recent content by Just2Bad

285/75/16 I saw in a parking lot a guy selling his renagade liberty with 285/75/16 MTR tires with stock rim but with ±1.5" spacers. Doesn't seems to be lifted that much. So it's possible to fit that big ? Maybe he's just mall crawling so he doesn't have to much rubbing ??? Can it...

Finally founded that's the UCA contacting with the spring, so I rmeoved the "weswaylift" until I can afford a-arms

swaybar well tighten

Yes but I might recheck...

Got it and did my trail. But now I have another problem since I reinstalled the boiler shim and the clevis lift(2 nuts) Everytime I hit a rock, hole, bump I ear a loud clunking noise coming from the suspension like if something was loose but it's not the case. From center of the wheel I'm...

how am I doing that ???? don't understand. I removed the bolt under the UCA but does nothing. I have a trail at night and ne to have this resolve :favorites68::favorites68::favorites68::favorites68::favorites68:

I'm looking in doing some front bumper trimming. I want to trim anything below the red line. When I look at the bottom of the bumper I saw some pins there that are holding the bumper. What will hold it in place at the bottom ??? Those of you who done some triming what have you done ...

will measure later my GF is out with the jeep

also the guy where I got the jeep aligned today told me that with my rear lift the support that hold the rear diff has a too prononced angle and that I need another support, is that true ?

No I never removed the UCA cause it wasn't necessary when I installed the wesway lift the first time, So I taught that the ome lift would be the same steps. Now that my libby got alligned today if I redo the wesway do I need to realligned again ?

I revome the sway bar and pushed down the lower control arm but it seems that it contacted with the spring and didn't wanted to get down further. the LCA need to go down another 1/2" to be able to just fit the 3/8" shim but like I said the UCA seems to contact with the spring and wont let...

I installed 2 months the so called Wesway lift. Yesterday got all my parts to install my OME/Bilstein lift. I were never able to set back the bottom of the clevis with the 2 lift on. I had to remove both my boiler shim and the conduct nuts cause even with only one of the shim or the nuts...

I'm a total newbie, so what do you mean by it need a sleeve ? this part is not coming with the shocks ?

I saw some saying BE5-A702-HO on lost and other BE5-6458-H7 which one should I buy ?

what about 235/85R16 ? it seems I can get tire that size for less than 245/65, but I guess it will rub everywhere ? I'm looking at Kumho Road Venture AT, good or bad ?