Recent content by Discus

Not sure how old it is. It's the brother in law's jeep. I bled them yesterday for as long as it took to get new (much lighter) fluid coming out. They are better but still a bit soft I think. I have to check that "bleeding from the ABS"

Never bled from the ABS module.... Will research out. I was about to just try to bleed them at the wheels. Thanks

Hi, i replaced the rear rotors and pads and usually you pump the pedal afterward and the pedal get stiffer again. This time, the pedal got a bit better but still have to push too far before it gabs. The jeep was parked for a 4-5 months prior the change the rack and pinion, the wte pump and the...

Well I took the grill, rad and fan and I was able to put it back together . Tomorrow I'll fill the power steering system and see if it all works. I changed the water pump also.

Iwill try tomorrow , not obvious though. Limited space to work with and the hole is pointing down. Will have to push it in and screw it at the same time. Thanks

Just found the 2nd image while searching the net. Should I just put it back in in that order?

I have another problem. Tried to take the high pressure hose off but the end that goes in the pump won't unscrew. Instead, the insert/nut at the pump is coming loose. I don't have access to hold both the insert and the nut of the hose itself. So I figured I could take both off and separate them...

Now I have a different problem. Tried to take the high pressure hose off but the end that goes in the pump won't unscrew. Instead, the insert/nut at the pump is coming loose. I don't have access to hold both the insert and the nut of the hose itself. So I figured I could take both off and...

It was just me being a bit of a moron... I just needed to turn the shaft 1/4 turn. I put in the way the old one was when I took it out but it must have turned while I was manipulating it to get it out.

Ignore, got it

Hi all, new to the forum and hoping to learn. I'm in the process of changing a rack and pinion on my step daughter's 2005 Jeep Liberty limited with a 3m7 engine. Got the old one out and got the new one in place (not bolted yet) but can't get the joint and shaft the mesh... can't slide the joint...