Recent content by CMCLEAN

Done the bed liner bit on my bumpers and fenders to cover the battle scars. Looked nice for a few weeks and then the dirt got ingrained and even a pressure washer wouldn't make them look reasonable. Next step was some masking tape, newspapers and a few spray cans of grey and clearcoat. Looks...

Around $250 for the hub assy is an average price. Not sure on the labor charge, but I reckon your tire shop must be owned by a couple of guys called Ben Doon and Phil Mckraken

Around 11mpg in heavy stop start traffic in Haiti with a 3.7L. Clean filter, new plugs etc etc, but A/C running all the time. Glad it's not in the U.K., I'd need to sell a kidney !!

Could do with new front springs on my KJ so I checked in with the local Hatian dealer of OME parts.. 2 Front Springs for a 3.7l no winch or ARB bumper - $600 and that doesn't include fitting. Next I checked for them in the U.K. thinking I would pick them up the next time I'm home on vacation...

In Haiti we pay about $4.50 per US gallon, supposed to be 95 octane, don't make me laugh, more like low 80's.

Not too sure about the interchangeability, but as far as replacing one, an easy job. Just replaced my drivers one this morning, a friend brought it all the way from Toronto for me. Anyway, take the 2 screws out of the door panel, one at the arm rest, other one is under a small plastic cover ar...

Bandit Steve, you could do the cheapskate Scotsmans way of raising your ride height. Loosen off the bolt that holds the clevis onto the bottom of the front shock and pull the shocker up a bit and the re-tighten the bolt. It probably would be a good idea to fit a spacer block to stop the shocker...

AlexKJ, can you advise if it's O.K. to substitute the Mopar Steering Fluid with ATF+4 as I doubt if I can obtain it where I am. Thanks

Also, make sure that your electric radiator fan runs continuiously. I had a bad connection on the fan relay and that caused the A/C to loose it's cooling effect and overheat the engine in slow traffic.