Recent content by blackhawk
-
P0765 Shift Solenoid "B"question.
Btw, if you have the diagram, you can check if UD solenoid is in good condition with a multimeter in ohm. It must be between 1.6 to 2.3 ohms (engine cold)- blackhawk
- Post #14
- Forum: KJ General Discussion
-
P0765 Shift Solenoid "B"question.
P0765 UD solenoid circuit Possible causes: Transmission control relay output circuit open Ud solenoid control circuit open, short to ground, short to voltage Transmission solenoid/Trs assembly Transmission control module Intermittent wiring and connectors (check this first)- blackhawk
- Post #13
- Forum: KJ General Discussion
-
Front Lower control arm and steering knuckle modification
Wow. What brand have you used ?- blackhawk
- Post #12
- Forum: KJ General Discussion
-
P0765 Shift Solenoid "B"question.
Engine, model, year?- blackhawk
- Post #2
- Forum: KJ General Discussion
-
Front Lower control arm and steering knuckle modification
Have you tried with moog ball joints?- blackhawk
- Post #2
- Forum: KJ General Discussion
-
Serpentine belt tension ?
Did you get an oem mopar map sensor?- blackhawk
- Post #4
- Forum: KJ General Discussion
-
KJ Reverse transmission problem
It will be nice to know the diagnostic- blackhawk
- Post #4
- Forum: KK General Discussion
-
KJ Reverse transmission problem
I guess that you have an electrical problem. I checked the dtc p0706 in all data program. See the possible causes in the attachment. Maybe all point at TRS (cable or connector of it} Btw, you posted this on kk forum instead of kj. Copy and paste, maybe you will have more opinions over there.- blackhawk
- Post #2
- Forum: KK General Discussion
-
Jeek KJ 2.8 CRD Limited - Advice Needed
Regarding the tpms system, if it flash occasionally is due to a bad sensor. You can scan with a tpms tool and it will tell you which one is out of order. The light also flash if the sensor is in other frequency....I mean, if you replace it with a different frequency. Kj comes with 315 and 433 mhz.- blackhawk
- Post #6
- Forum: KJ General Discussion
-
YACNS issue (Yet another crank/no start issue)
If I were You I would check the fuel pressure in ralentí and in the road! Sometimes you got a good reading in ralentí but not in the road in different scenarios- blackhawk
- Post #5
- Forum: KJ General Discussion
-
Air flow does not go out in front position
It has to do with vacuum. I have had same intermittent issue , it really works after 5 minutes of riding- blackhawk
- Post #2
- Forum: KJ General Discussion
-
2006 Fog Light replacement
No, they don't fit as replacement of stock ones.- blackhawk
- Post #2
- Forum: KJ General Discussion
-
06 liberty fuel filter ?
There are only two filters in the module assembly, one tiny which is outter and the conic one that can't be replaced as it's encapsulated- blackhawk
- Post #3
- Forum: KJ General Discussion
-
06 liberty won't start
Check both the ckp and camshaft. It being bad, the engine starts after several tries- blackhawk
- Post #8
- Forum: KJ General Discussion
-
ABS module rebuild
You need a reliable scanner such as autel or launch to perform the reprogram. It's done installed in the vehicle and need to perform some drive test to match.- blackhawk
- Post #9
- Forum: KJ General Discussion
