Recent content by 4x4kingx889

Having a problem where overdrive grabs but slips before I pull ****** I removed valve body to make sure it wasn't a bad accumator plate but upon removal I seen it said "transgo" so I assume its aftermarket? Also if u look at pics the one piston is different is does not have a thing in spring...

schuylkill county pa

I modded the HVAC control's to allow the ac to run on defrost only I see no point in having the ac on when you have it on floor only.

Which filter are you talking about the sump filter or canister filter? I installed the canister filter like a regular oil filter...and like I said it drive's/shift's great until overdrive which like other's have told me make's me think there's damage...

You think it will hurt anything ( besides fuel milage ) to drive it with od locked out? Sent from my Nexus 4 using Tapatalk

Those gagues look sweet Sent from my Nexus 4 using Tapatalk

Bummer...what's involved with pulling the ****** out of crd? The exhaust have to come off? Ill try to get winter out of it and maybe deal with it In Spring... Sent from my Nexus 4 using Tapatalk

Ok the other week I had a problem with my ****** I took the pan off and seen the plastic peace that screws into the canister filter broke and the filter was laying in the pan and the fluid was burnt...put new fluid in all the code's went away and it shift's and drive's fine except over drive it...

Any one have a picture of a silver kj with moab wheels? Thinking of trading/selling my procomps as there's to much back spacing for my likes and would like to try moabs sent from my sgh-1717 running CM10

Very excited sent from my sgh-1717 running CM10

Also if you have a evic you can adjust the timmer Sent from my SAMSUNG-SGH-I717 using Tapatalk 2

Cleaned it Sent from my SAMSUNG-SGH-I717 using Tapatalk 2

if you dont mind me asking how much were they? they look really good!

Can any one with a flat hood post pictures of under there hood? from looking at part number's it appears all you need is the grill and the hood but it can't be that easy can it?

Yeah I found some hood's close by I just need to know all the part's I need