ikuo78's latest activity
-
ikuo78 replied to the thread Upper control arm alternatives.Whether it's a fake or sold directly from the manufacturer, you can buy it on amazon.com. -
-
ikuo78 replied to the thread 2004 liberty Rebuilding the front end on my moms jeep and found a lot of fluid in tie rod boots.I would like to believe that this is possible if it is on the passenger side.
-
ikuo78 replied to the thread 2004 liberty Rebuilding the front end on my moms jeep and found a lot of fluid in tie rod boots.thank you. Looking at the photo of the seal kit, it looks like one of the end seals is simply fixed with a C ring. I'll check to see if...
-
ikuo78 reacted to KJowner's post in the thread 2004 liberty Rebuilding the front end on my moms jeep and found a lot of fluid in tie rod boots with
Like.
Seal kits are available, I've not rebuilt one so I don't know what's involved. Right hand drive racks are available in the UK and I... -
ikuo78 replied to the thread 2004 liberty Rebuilding the front end on my moms jeep and found a lot of fluid in tie rod boots.Mine too. Is there space outside the end seal for additional end seals? Or, is it possible to replace only the end seal? without...
-
ikuo78 replied to the thread Newbie question about lift kits.Even with a lift, there is a high chance of rubbing. Mine is an RC 3 inch lift with a wheel offset of -16mm and a height of 21.5...
-
ikuo78 replied to the thread Front strut length.Although it is sandwiched like this, The shock side is press-fitted. It's made of aluminum. I don't think repressing it will work.
-
-
A couple of things combined, but generally all relating to too much lift... 1) The sway bar geometry was out of tolerance. Even after...
-
I found this on a Japanese auction site. It looks like Procomp's member down kit for KK. Does it look like the front could be used for...
-
-
ikuo78 replied to the thread Front strut length.Thank you. It's very useful here. Not having a ladder frame also makes things difficult. Currently, I am satisfied with the spacer lift...
-
It's an unfortunate situation caused by the independent front suspension. The H&R springs are longer and a progressive rate design I...
-
ikuo78 replied to the thread Front strut length.By increasing the shock length and using a spring with the same spring rate as the stock but with a free length 1 to 1.5 inches longer...
-
Yea that's what I thought. I'm thinking more simple than that. I run OME springs with Boiler plates. If I could find front shocks 3/8 "...
-
ikuo78 replied to the thread Front strut length.This is a very interesting post. In other words, the OME spring increases preload to provide lift. In order to achieve high preload with...
-
ive been reading around and from what i have gathered is that if i am going to run the ome hd coils up front, my new strut will be the...
