Latest activity
-
Eskiio reacted to CheddarGau's post in the thread Coolant leak, full resevoir gone in 24 hours, should I replace water pump? with
Like.
If the leak is pretty bad fill with water, run it and then let it sit once on the warm side. If it's a bad leak you will see the water... -
Eskiio reacted to KJowner's post in the thread Coolant leak, full resevoir gone in 24 hours, should I replace water pump? with Like.
I doubt it's the timing cover, they don't normally have anything to do with coolant (I'm not familiar with the engine so general...
-
AJust bought the truck and it was making an awful noise, like maybe a bad throwout bearing. After getting it home, I find it's the A/C...
-
ikuo78 reacted to u2slow's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
Bilsteins aren't worth paying extra for IMHO. Ours had them on the rear and I went to Monroe's after lifting. On my Dodge, Bilsteins... -
ikuo78 reacted to KJowner's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
H&R springs and some new shocks will freshen it up nicely.
-
Yesterday I pressure washed Giddyups underside to prevent as much dirt as possible from falling into my eyes as I dropped her fuel tank...
-
In order to finish off the in tank LP install, I drilled a hole in the unibody, behind the drivers seat and under the carpet, for the...
-
Wifey had major surgey and is recovering well, so finally had some time to work on Bert in between wound care and drain purges (gross...
-
Gyro replied to the thread What size bolts are used to mount the skid plates?.4x Bolt M10X1.50X35 and x4 rivnuts are also needed. Gyro -
Wifey had major surgey and is recovering well, so finally had some time to work on Bert in between wound care and drain purges (gross... -
KingKJ posted the thread What size bolts are used to mount the skid plates? in KJ General Discussion.I took of my transfercase skid and 3 out of 4 bolts tore the part inside the body/crosmember out and I need to find the size so I can... -
KingKJ replied to the thread removal of transmission in a day, is it possible?.SUCCESS!!!! I completed this yesterday without breaking the transmission or making a huge mess, it was honestly not as bad as I thought...
-
TReplace the stainless bits the pads slide on too if they are worn. As Gyro said tgs hoses are definitely worth looking at after 20 years...
-
TFlush new fluid through before replacing caliper, that way old fluid never gets in new caliper.
-
TFront flex brake hoses. Gyro
Members online
No members online now.