Latest activity
-
Quick update. After getting the rocker reinstalled I told her we were going to reassemble the engine before we pull the head and see how... -
Rene_05 replied to the thread 4.10 Re-gearing - 2025.Know a lot of folks go the junk yard route, but I preferred new. The rear gears seem readily available in a number of places. Seemed... -
-
DDeVilliers replied to the thread chasing the elusive front end clunk.I have the same clunk. Even rough gravel it's a big rattling sound. I also have a 2 inch lift. Replaced the clevis bushes and it's...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.At least it isn’t just me, but you at least got some quotes! A ‘Jeep’ off-road shop essentially told me to pound sand because of the age...
-
DOMG, youre right … lighter wallet means less weight which means better MPG's .. cant wait to tell my wife !!! Hmmm…. maybe not, she...
-
DWent out with the local off road club on Sunday - got up into some snow - was a good day!
-
Last night my daughter and I drove her 2009 KK ,AKA Quackers, to her dance lessons. She drives and I sit shotgun since she is not 16... -
-
ikuo78 replied to the thread Shock Recommendations.The rubber bushing can wear down to the point where a gap appears between the mounting eye's inner sleeve and the rubber bushing. When... -
-
22TALL1 replied to the thread 4.10 Re-gearing - 2025.I’m in eastern Oregon and about to take the same adventure. It’s actually astonishing to me how few people do gears anymore. The quotes...
-
I was able to find a guy in Texas who had made a few rear bumpers who still had one mostly complete. I paid him to finish it for me... -
This green madness drives me nuts! -
Hello, My name is Dirk, I’m from the Netherlands and new to Jeep and 4x4’s. I recently bought an ‘05 Cherokee KJ (Liberty in the US)...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.Sharing a few good threads with tips on removal of the front diff...
-
Rene_05 replied to the thread 4.10 Re-gearing - 2025.This is why this forum is great, thank you. This might be the way to reduce labor cost, still learn from the experience and also find a...
