head gasket

  1. libertyandfreedom

    New here with 06' liberty

    Hello! I bought this Liberty in Dallas, Tx. In July 2022. 2 weeks after I bought it the battery died. I replaced it with a cheap autozone battery, and surprisingly it's held up even after jumping over 100 vehicles. Then a week later my alternator stopped working, and so I opted for a new...
  2. B

    Rough idle/will barely idle.

    Recently had a blown head gasket and ended up replacing the right side cylinder head. At initial start up the engine ran really rough. The code I got was a P0300 random misfire code. I replaced the coils and spark plugs. Still runs rough. I haven’t checked the injectors yet simply because barely...
  3. M

    Got them Head off, Now what...?

    I am so excited that I found this group...so much info and so many people appreciative of our Jeeps...the "Libertys." My Liberty 2008 has about 180 thousand miles has always been dependable till last summer, when trans fluid was leaking, which I immediately fixed (found out that the trans fluid...
  4. T

    2012 KK 3.7L stuck head bolts??!!

    .....am in to a head gasket set replacement job, 2012 KK 3.7L. Got all bolts out except for one each bank. Both are stuck, or at least very resistant to loosening further and rather than keep going and risk snapping them off does anyone have any suggestions?? Setting up a date with Mr. Heli-Coil...
  5. R

    Recommendation for Repair Shop in Denver Area

    I believe I have a blown head gasket on a 2005 jeep liberty CRD. I need recommendations on where I might get it repaired. I am considering doing it might self to try to keep the cost down. It might be more work and a little above my skills. Plus my age of 68 makes it harder for me to work around...
  6. M

    Jeep liberty 3.7l replaced head gasket now wont start

    Hi I am new to the forum. I am having a very frustrating experience with this car and need some help. I replaced the head gasket and now the car wont start. Ive done head gaskets successfully before but I am no pro. I had the head machined, new gasket set obviously, new timing chain set, new...
Top