Search results
-
Fram oil filter updated.
Doing an oil change today I noticed Fram modified their filter. Less metal to secure the threaded mounting area. A more recessed face, and more oval shaped holes. I've been using Fram for years without issue, but.............. Does the threaded area (filter on left) look risky? Mayby the new...- AZWFO
- Thread
- Replies: 15
- Forum: KJ General Discussion
-
Stealership Carwash-maybe not a good idea
Why my purposly spotless KJ was subjected to a carwash after service work at a local dealer is unknown, but the result was both power side mirrors are dead. Fuses check out ok. Hi-pressure water or the air dry seems to have pushed water inside my door and killed the switch. A new $32.00 switch...- AZWFO
- Thread
- Replies: 8
- Forum: KJ General Discussion
-
10 Years Gone
Celebrating 10 years of my KJ. !! Original owner, with 125K sure footed miles! Built 4/01, Purchased 7/01- Remember when yours was new? or new to you.. BTW - Celebration included EMU install complete with shocks and new upper control arms and fresh Yoko's Rollin-on.......:favorites13:- AZWFO
- Thread
- Replies: 5
- Forum: KJ General Discussion
-
Front Diff Artwork
I knew my front diff drain and fill plugs were a little "comprimised" over the last few oil fluid changes, and noticing some leakage, last week I changed out the diff fluid after only 6k miles and installed new fill/drain plugs. 800 miles later I'm shocked to see the same leak but more focused...- AZWFO
- Thread
- Replies: 5
- Forum: KJ General Discussion
-
Replaced My 02 Liberty Headlights
My headlights were so worn and fogged out I decided to replace them rather than polish them for 4 hours with 15 different sandpaper grits. I paid $118ea, that included the bulb as well. Replacement was pretty easy, just needed a T20 Torx. I can see again!:D- AZWFO
- Thread
- Replies: 14
- Forum: KJ General Discussion
-
How to change 02 Liberty Washer Pump
Safely jack-up and remove the right front wheel. Use Jack stands for added protection, lift up the small wheelwell flap to access the washer motor. You may also remove and isolate the negitive connection at the Battery. Using a small probe or screwdriver, slide fully upward the red connector...
