Search results
-
B
Injector to fuel rail retaining clip trouble
Hi, I replaced a fuel injector on my 3.7, which involved removing the right hand fuel rail. Upon reassembly, I found the retaining clips very difficult to position, ensuring I had the rail tab slotted into the clip. Is there a trick to it? Has anybody got a tip for a tool to use? Thanks...- branny
- Thread
- Replies: 2
- Forum: KJ General Discussion
-
B
Fault Code O0201 - rough idle
Running on the highway today i got the check engine light. The engine had been, very slightly rough, not really anything to speak of. The code was P0201, and with the check light the idle after stopping got very rough. I felt like i could 'rev out of it' and it would run ok again. P0201 =...- branny
- Thread
- Replies: 33
- Forum: KJ General Discussion
-
B
2004 Liberty 3.7 smoking under hood
Anybody know what would cause this? I smell burning often, i thought that was valve gasket leaks. Perhaps rad cap blowing coolant? https://youtu.be/AtbBBgXl-Bo- branny
- Thread
- Replies: 15
- Forum: KJ General Discussion
-
B
2004 Liberty Sludge in Oil fill neck
I have a 2004 3.7L 4x4 Liberty with 90k miles. I tend to get a heavy build up of white sludge under my oil cap. The car runs fine and the oil on the dipstick looks good (it was serviced recently). The coolant system is clean and has never had a noticeable drop in level. I recently had the PCV...- branny
- Thread
- Replies: 95
- Forum: KJ General Discussion
-
B
O2 Sensor - Code P0137
This is my first post, i have had my 2004 Jeep Liberty 3.7L 4x4 for 18 months and keep getting niggling problems. I usually search the net and end up using info from this site, so i thought i should join! Today my Check Engine Light came on, checking the code using the ON OFF method gave...- branny
- Thread
- Replies: 2
- Forum: KJ General Discussion
