Search results

  1. DadOSix

    Belt tensioner bolt stripped

    .
  2. DadOSix

    HOW TO: Change Transfer Case Position Switch

    There is nothing on the dash when you are in 2wd. The lamp shows when the transfer case is in other than 2wd. My 06 is a bit different that my 04. But I do think that 04 shows “part-time” when in 4Hi
  3. DadOSix

    Hard brake pedal and hard to stop

    Caliper binding / or not re-installed correctly Pinched brake line / hose Brake line in the frame damaged when you were doing UCA’s (on the KJ - that funky captive nut with a flag to keep in place can and will clip the brake line if it gets away from you. Not sure on KK - never saw one up close...
  4. DadOSix

    Reverse to drive dead zone.

    Check your transmission fluid level
  5. DadOSix

    Did i get the wrong regulator

    So - if it works a few times and then binds at the top, it may pop off again. Not a bad regulator, but now you know where and what to look for.
  6. DadOSix

    Did i get the wrong regulator

    Future reference - pull the hair pin. Slip the stud into the plastic and then slide the hairpin back in place.
  7. DadOSix

    Did i get the wrong regulator

    So, what you took off is the OEM style. The 660545 picture is a new version - what is important is the white nylon clip. It should look the same (more or less) as to what you took off. When these break one of a few things happen : 1 - motor locks up - rare 2 - cable binds in the track and...
  8. DadOSix

    2003 KJ - fail of 4wd for a short time.

    Best way to do it! Who really decided we need a lamp to show position? Well done!
  9. DadOSix

    Did i get the wrong regulator

    Front regulator: Has a wide nylon clip Rear Regulator: Has a narrow nylon clip to hold the window. I can’t make my picture paste over on the ipad. Maybe you can post the part number from Rockauto?
  10. DadOSix

    2003 KJ - fail of 4wd for a short time.

    Also - please be aware that just because the dash lite says you are in 4, or part time, does not necessarily mean it is so. The transfer case switch gets ‘gummy’ and the indicator is not accurate. A new mopar switch will solve this, if that is what it is. The person I got my 06 from, also...
  11. DadOSix

    A Few Electrical Questions

    http://www.colorado4wheel.com/manuals/Jeep/KJ/ - i lifted this from another member’s post!
  12. DadOSix

    low oil pressure after general inspection. KJ 2006 3.7

    The engine should be warmed up - so water temp here would be 175F to about 205F. I think a new sensor should solve the oil pressure light problem.
  13. DadOSix

    First-time jeep/liberty owner

    Agreed with all of the above! If you run into a failure, dont just start changing parts. It is cheaper in the long run to diagnose rather than guess due to a scanner code.
  14. DadOSix

    low oil pressure after general inspection. KJ 2006 3.7

    With LibertyTc's chart, it looks like you are in range. Leaking thru the switch is likely the issue. Replace it and that should get rid of the light. Use Mopar part if you can get it. I am surprised the curb idle psi is so low on that chart.
  15. DadOSix

    Re-visiting my siren problem

    Re- reading the orignal thread and this, you mention a ‘siren’ - As far as I know, the jeep KJ series used the vehicle horn to alert on the system. If you do have a siren, it seems to indicate an after-market alarm kit. If that is so, you might need to crawl under the dash and see if there...
  16. DadOSix

    low oil pressure after general inspection. KJ 2006 3.7

    The only way to tell for sure is to attach a mechanical gauge to the engine and see the actual pressure. That oil sender is just a ‘switch’ and they can send a low pressure signal at times. Perhaps the port (orifice) on the switch is plugged up or partially obstructed by oil sludge. Also...
  17. DadOSix

    2006 liberty limited automatic transmission failed

    Some local shops rebuild yours, others buy reman and swap out. I would prefer my own unit rebuilt.
  18. DadOSix

    Power Steering Issue

    Interesting thought on the cooler. I would *think* return side. I will look as soon as one comes home today.
  19. DadOSix

    6 beeps when parked

    If your jeep has evic (overhead console). It may tell you. Justanswer suggests a maintenance interval needs reset. I have never had either of mine do this, so i am just spit-balling
  20. DadOSix

    Power Steering Issue

    If your pump is not leaking all over the jeep, you may be drawing air in the return line, or have a leaky rack and pinion. Hard to tell on the R/P unless you peel an inner boot back. Got a lot of fluid behind the boot? That is likely it.

Random media

rear suspension cad
Roof Rack Installed
6001.jpg
NCM 0189
Stock Libby can do great things!
photo[3]
2531.jpg
Fun on the Ice
Rear Hatch glass switch for handle. Was corroded internally. Kept Shorting

Latest posts

Members online

No members online now.
Total: 533 (members: 0, guests: 533)
Top