Search results
-
P
Noise's again
Rubber bushing rotted out on your Upper A-arm?- Pt420
- Post #20
- Forum: KJ General Discussion
-
P
Help-Idle issue
Pretty much vacuum system been replaced checked all lines no leaks either. I am thinking egr valve going to take it off clean it real good see what happens before buying new one. As for gas I buy there all the time and just put fresh gas in from there. I only had about 1/2 gallon left in when I...- Pt420
- Post #3
- Forum: KJ General Discussion
-
P
Help-Idle issue
I have a 2007 Jeep liberty limited I replaced the throttle body, ignition coils, spark plugs,y pipe cats, all 4 O2 sensors, PVC valve, crank case vent tube, evape.purge Canister, evaporator detection pump, fuel pump and after replacing the fuel pump ran good for a short drive to gas station...- Pt420
- Thread
- Replies: 4
- Forum: KJ General Discussion
-
P
Noise's again
Have you checked your ball joints. Upper and lower?- Pt420
- Post #18
- Forum: KJ General Discussion
-
P
Noise's again
- Pt420
- Post #17
- Forum: KJ General Discussion
-
P
OME lift kit - which control arms needed?
There is a recall on those control arms. First look into that before spending all the money maybe get them to replace what you get. As for what ones I couldn't tell ya. Sorry- Pt420
- Post #15
- Forum: Lift Kit Discussion
-
P
Transmision Crossmenber
I figured it out all I had do to get it lined up was lift the ****** more it's on now. I thought it was lifted as far as it could it wasn't.Thank you -
P
Transmision Crossmenber
Put a transmission in from a 2003 Jeep liberty into my 2007 Jeep liberty Neither cross member will work for it any idea on what I can do to mount my transmission to the frame? The 2003 has two ends that have slight right angle the 2007 is straight across. Fixed problem all good. -
P
Transmission
I have removed the transmission, front carrier, and transfer case put another carrier in in process of putting a 2003 Jeep liberty transmission in place of my 2007, as I was putting everything in place I noticed there is plug for the 2007 that the 2003 does not have all others are right where... -
P
Transmission
I have removed the transmission, front carrier, and transfer case put another carrier in in process of putting a 2003 Jeep liberty transmission in place of my 2007, as I was putting everything in place I noticed there is plug for the 2007 that the 2003 does not have all others are right where... -
P
Transfere case
Both are exactly the same. 2Hi-4Hi-N-4L P- R-N-D-2-1 both in this order 2Hi-4Hi-- Pt420
- Post #12
- Forum: KJ General Discussion
-
P
Transfere case
Thought is what I thought you where saying get back to you tomorrow will check both out I know both handle are same place look exactly the same as for letter I will get back ya ya on that. Thank you.- Pt420
- Post #11
- Forum: KJ General Discussion
-
P
Transfere case
New at this been working on replacing the transmission so when you ask "on each handle in the cabin" what is that you are asking for? I posted the picture of the part number of both of them. I am assuming they are different. The 2003 goes with the transmission I am putting in I was told by a...- Pt420
- Post #9
- Forum: KJ General Discussion
-
P
Transfere case
- Pt420
- Post #6
- Forum: KJ General Discussion
-
P
Transfere case
I don't know I attached to this several times they are coming upon here. I also I meant transfere case worded it wrong fixed it.- Pt420
- Post #5
- Forum: KJ General Discussion
-
P
Transfere case
I have a 2007 Jeep liberty limited and a 2003 Jeep liberty sport the 2003 has only 77,000 miles on it and was wondering if the tansfere case from it can be put on the 2007 limited. First photo is from the 2007 the second is from the 2003.- Pt420
- Thread
- Replies: 16
- Forum: KJ General Discussion
-
P
Engine swap
Ok this is for a 2003 to a 2007 now I just need to figure out 2007 to a 2003 is the one replacing it. From what I gather the rings no matter what way will have to be changed now I wonder if I am going to have to take other parts from the 2003 and replace the 2007 parts to fit the 2003 engine...- Pt420
- Post #7
- Forum: KJ General Discussion
