I did install JKS quick disconnects for a JK, but the pins that stay on the vehicle interfere with the steering knuckle at full lock. So I reverted back to the stock sway links.
I remove the stock links when going off road on tougher trails. It only takes 5-10 min to do on flat ground before and...
Given my low post count, I cannot PM @LabRat or reply to your thread in the "Wanted" section.
Here are some center caps from eBay, these are the ones that use the lug nuts to hold in place (I prefer these) instead of screws from the backside.
eBay Center Caps
I mounted a Viair 380C air compressor in the rear window area.
It mounted on a plate mounted to the unibody.
Mounted underneath the plate is the pressure switch and pressure regulator.
I chose the 380C for it 100% duty rating and 200 psi rating. It is not super fast, but it works great.
You will need grill, header panel, fenders, and fender flares to start with. Making the front fender flares from 02-04 do not work with 05-07 rocker trim.
I would also recommend an Ignition Switch Actuator Pin. They can go bad without warning, but when you do, they leave you stranded. They take up very little space. I believe you need a T-10 security torx to replace it. There are a few videos on how to replace them.
Along with oil(s) as Tom...
I had a set of General Grabber A2s on my Subaru Forester, and they did fantastic in the snow.
After they were installed, I found a snowy parking lot to do donuts in, but they had too much traction.
I know when my Eaton TrueTrac installed, the shop had to replace the ring and pinion as well because of larger bolts to hold the ring gear to the carrier.
DTT is Detroit TrueTrac limited slip differential.
https://www.eaton.com/us/en-us/catalog/differentials/eaton-detroit-truetrac-differential.html
I have them installed and have been very happy with the performance.
If you do have one wheel in the air, lightly holding the brake while...
As long as your bolted joint stays tight there is no significant issue. Even if all the rubber on the top of the steering rack is gone, the worse you will have is a rattle/knock from the rack moving slightly.
If you can remove the bolt, and put some sort of “rubber washer” item in there, it...
Had a awesome time in Moab and met up with some TJ folks.
I will have to go through and sort pictures, but here are some starters.
Trails we did:
-Hurrah Pass and Chicken Corners
-Schafer Switchback and Potash Road
-Fins and Things
-Hell's Revenge (Didn't use any of the easy bypasses, but did...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.