Search results

  1. HoosierJeeper

    Rear upper control arm...

    Yep, that's the same one. Oreillys has it too. I just got it locally since I figured if it breaks it'll be easier to swap out. I think most people have issues getting the bushings out, the arm just bends.
  2. HoosierJeeper

    Rear upper control arm...

    FWIW, I'm running a Napa Supreme one (think it's made by spicer), one with the blue boot, been there a few months and on a few off road trips, it's been good.
  3. HoosierJeeper

    Rear upper control arm...

    What brand did you use?
  4. HoosierJeeper

    Radiator question.

    Not sure, I'm usual outside watching the Jeep lol.
  5. HoosierJeeper

    Radiator question.

    All I do is mine is fill it through the bleed hole, tighten that back up, fill tank to proper level and then let it idle with the cap off and wait a few minutes for it to "burp" and the coolant level in the reservoir drops, then refill and done.
  6. HoosierJeeper

    Feeler - Detours USA Backbone Winch Mount

    Might be getting an ARB bumper.... would anyone be interested in the Detours backbone? Winch mount that allows you to run a winch with the stock bumper. Discontinued now I think. Thinking maybe $300 or better offer?
  7. HoosierJeeper

    Switching to an ARB from Backbone?

    Found a used ARB bumper that I might get if I can get a good deal. Right now I have the Backbone on the KJ for my winch. I don't remember doing any heavy modifications to mount that, but is there anything I would've done to the KJ then that would make the ARB harder to mount? And, while I have...
  8. HoosierJeeper

    2003 Control Arms and Suspension.

    Lots of info on here for the lifts.... do an OME lift. I'd recommend JBA upper control arms too so you can replace upper ball joints instead of the whole arm. OEM lower control arms are like $700 each. I'd buy the nicest bushings you can find and put those into your current control arms. FWIW...
  9. HoosierJeeper

    Fan clutch nut

    36mm fan clutch wrench.
  10. HoosierJeeper

    Clunk going over bumps on 06

    No rear sway bar bushings on the KJ. Mine had some creaking from the rear and it was just sand/mud caught in the LCA bushings. cleaned it up and it's quiet. OP, what happens when you go like 5MPH and slam on the brakes? if it pops then, the lower control arm bushings are probably shot.
  11. HoosierJeeper

    Coolant leaking engine 3.7 L

    Upper radiator hose? Double check WP and radiator. things can get blown around and drip onto a different side than they originated.
  12. HoosierJeeper

    Oil light came on

    Just replaced mine this week, easy job.
  13. HoosierJeeper

    What did you do to your jeep today?

    Finished putting it back together after replacing the oil pressure sensor.
  14. HoosierJeeper

    Bad oil pressure sensor?

    Finally replaced the switch and all is good now!
  15. HoosierJeeper

    What did you do to your jeep today?

    I know of a certain 2015 Cherokee that would be for sale if a buyer came along.....
  16. HoosierJeeper

    Time for 4.10 gears!

    Good to see you back! I want to do this to mine too.... eventually... gotta get the Rene beefed up tho.
  17. HoosierJeeper

    What did you do to your jeep today?

    Past few weeks..... 1. Rear section of the roof got replaced from some rust starting under the the flipper glass.... $1300 later but looks new! 2. Took rock rails off last weekend to paint 3. POR 15'd a few little rust bubbles on the rockers. Don't care about it being pretty since they're...
  18. HoosierJeeper

    Got new tires on the Renegade!!!

    Yes! KJ is getting a set next year!
  19. HoosierJeeper

    Got new tires on the Renegade!!!

    Decided to get rid of the wimpy stockers...got Toyo Open Country AT3s up a size from stock!
  20. HoosierJeeper

    Replacing BFG's

    I just put Toyo Open Country AT3s on my Renegade Trailhawk and absolutely love them. They look great and are as silent as the factory tires were.
Top