u2slow's latest activity
-
u2slow replied to the thread Cardone cv axle.The passenger shaft inner spline coupling is often buggered. So look for that inner shaft too. -
u2slow replied to the thread Cardone cv axle.https://www.jeepkj.com/threads/any-suggestions-on-where-to-buy-cv-axles-for-kj-2006.80059/#post-811750
-
u2slow replied to the thread Any suggestions on where to buy CV Axles for KJ 2006????.I'm not convinced there is much to go wrong with CV axles in normal service. The exceptions would be really hard use, over-angulation...
-
u2slow replied to the thread Any suggestions on where to buy CV Axles for KJ 2006????.11 years so far. About 3" lift. Cradle is dropped 3/4" to help angles a little. The occasional forestry or radio-tower road. Nothing...
-
u2slow replied to the thread Calibrate Speedo AGAIN AFTER I Regear?.Speedo reads off the differential ring gear, so there is no change with axle ratio. What does affect the calibration is larger tires. I...
-
u2slow replied to the thread Can I Fit ANY 4.10 Gears by Just Adding ANY Steel Dana 30 Carrier into the Dana 30a “Super”?.No, you need specific Dana 30A r&p and pinion bearings for the KJ. The pinion is fatter. I'm not sure if the carrier bearings OD is...
-
u2slow replied to the thread NEED 4.56 RING AND PINION FOR MY KJ.Are we talking about the whole diff? Or the internal carrier 'case' that the ring gear bolts to? The latter item may fit all kinds of...
-
u2slow replied to the thread NEED 4.56 RING AND PINION FOR MY KJ.I have it on good account that the North American CRD (only offered '05-06) were 3.73 ratio. What I know of the 30A r&p is the pinion...
-
u2slow replied to the thread Installed Iron Rock Rear UCA today..Longer arms may help, but at some point you will need a longer driveshaft, or a driveshaft spacer. Basic right-angle triangle geometry...
-
u2slow replied to the thread Rancho RS5764.I put Rancho 5000 series in the front of ours. That could be the model number. I put them in with the diesel springs. They have done the...
-
u2slow replied to the thread Broken top strut mount? Please help.Makes sense. What I do know is I didn't take the control arm off the cradle because that's the alignment adjustment I paid for!
-
It’s no problem at all with the struts assembled but my problem is the top mount broke which effectively released the compression on the...
-
u2slow replied to the thread Actual downsides to spacer lift.I don't get the 'pre-loading' critique with spacers. Spacer on top pushes the wheel hub further away from the body. That's lift. What's...
-
u2slow replied to the thread Broken top strut mount? Please help.Managed to get the struts out and back in without a spring compressor or removing the lower control arm. Been too long to remember the...
