Recent content by riggler

Thanks for the reply i bought the ome 1.5 kit from jba Front: CRD HD OME2790 Springs 90009 Strut with 2 conduit nuts Rear: Diesel-Med OME2948 Springs 60069 Shocks while the existing ball joints are perfect, after some extensive reading here I think i will regret not doing the jba...

Ok , a little more info....The wheels were delivered, they are 6 spoke 17" x 7.5", the spacing from flange face to rim edge (rotor side) is about 5 9/16"..... not what was shown in auction specs....though the refinish work is close to perfect both front and rear from center to bottom of flare...

im not sure what your question was.... my question was asking what tire will work with a 17 inch factory wheels that i just ordered ? that is of course with my girly man lift... then again it is also my wifes dd, no baja pre runner here, but we do run the beach and get into quite a bit of...

gee thanks for the replys... guess i should give my signature 2005 crd limited,(red) new head and everything that goes with it..., euro torque, gde full torque and trans , weeks squatch kit front:OME2790 Springs 90009 Strut, 2 conduit nuts(factory balljoints perfect) rear:OME2948 Springs...

Hi scott, also pm`ed you... just ordered a set of refurbished 17" (17"x6")wheels on ebay that look like yours in your avatar....with your tires, did you have to use a spacer or just bolt the wheel up ? with my crusty 16 inch aluminum wheels and 235/70r16 tires i can just barely get my fingers...